Platinum Series Steakhouse Broiler User Manual

STEAKHOUSE BROILER
OWNER’S MANUAL 1190950 REV 2 (11/14)
PAGE
8
OF 22
INSTALLATION
6. If the broiler is not already attached to the stand, locate and set aside the four ¼”-20 bolts and lock washers provided
with the stand.
7. Lift the broiler (using two people is recommended) and place it on the stand so the holes in the mounting ange align
with the corresponding holes in the stand (see Figure 5). The valve panel ange should sit ush with front frame of the
stand. Secure the broiler to the stand with the ¼”-20 bolts and lock washers. (Depending on the size and weight of
the broiler, it may be helpful to remove the griddle plate before lifting the broiler. To do so, remove the body sides to
access the griddle-plate mounting bolts.)
8. Go on to Step 3.
Figure 3
Mounting Broiler on Stand
Fasten broiler to stand with four 1/4-inch bolts here.
If assembled broiler is too heavy to lift, remove side panels
and then remove griddle top by removing four bolts.