Platinum Series Steakhouse Broiler User Manual

OWNER’S MANUAL 1190950 REV 2 (11/14)

PAGE

OF 22

STEAKHOUSE BROILER

STEP 2A: MOUNT ON HEAVY DUTY STAND AND ATTACH RESTRAINT

The stand is crated separately, but is shipped with the broiler. Depending on the shipping requirements, the broiler may

already be assembled to the stand.

INSTALLATION

NOTICE

For an appliance equipped with casters, (1) the installation shall be made with a connector that complies with the

Standard for Connectors for Movable Gas Appliances, ANSI Z21.69 or Connectors for Moveable Gas Appliances,

CAN/CGA-6.16, and a quick-disconnect device that complies with the Standard for Quick-Disconnect Devices for

Use With Gas Fuel, ANSI Z21.41, or Quick Disconnect Devices for Use with Gas Fuel, CAN1-6.9, (2) adequate

means must be provided to limit the movement of the appliance without depending on the connector and the quick-

disconnect device or its associated piping to limit the appliance movement, and (3) the restraining means should be

attached to a frame member on the back of the appliance.

1. Secure the restraining-cable bracket (item “B” in Figure 4) to a wall stud located as close as possible to the connection

point of the gas-supply line (and the pressure-regulator vent line, if a vent line is in use). Use four #12 screws (items

“C”) and plastic anchors (items “A”), if necessary.

2. Install eye-bolt (item “F”) to a frame member on the rear of the appliance. After checking carefully behind the frame

member for adequate clearance, drill a 1/4” hole through the frame member.

3. Thread hex nut (item “G”) and slide the washer (item “H”) onto the eye-bolt. Insert the eye-bolt through the 1/4” drilled

hole and secure with a washer (item “H”) and nylon lock nut (item “I”).

4. Using the spring-loaded snap hooks, attach the restraining cable to the bracket and the eye-bolt.

5. Using the cable clamp (item “D”), adjust the restraining-cable extended length to prevent over-bending or kinking of

the gas line (and vent line, if in use).

Figure 2

Installation of Restraint