Platinum Series Cheesemelter User Manual

OWNER’S MANUAL 1186531 REV 6 (9/14)
PAGE
7
OF 22
INFRARED CHEESE MELTER
If the cheese melter is to be mounted over a range, a special ue riser is shipped with the cheese melter and range.
Depending on the shipping requirements, the cheese melter, ue-riser, and range base may already be partially or
completely assembled.
1. Attach the ue riser to the rear of the range using the installation procedure included in the range manual, but do
not attach the wall shield (the back of the ue riser) yet.
2. Lift the cheese melter (using two people is recommended) and hook the cheese-melter-hook over the top-front
edge of the ue riser. If necessary, move the cheese melter left or right so that the holes in the top of the cheese
melter-hook line-up with the holes in the top of the ue riser, then secure the cheese-melter-hook to the ue riser
using three #10 self tapping screws provided.
3. Secure the bottom of the cheese melter to the ue riser with the four 1/4” self-tapping screws provided. The holes
are accessible from the rear of the unit behind the wall shield.
4. Attach the wall shield, which forms the rear of the ue riser. The gas supply inlet extending out from the rear of the
cheese melter should be accessible through the corresponding hole on the back of the ue riser.
5. Go on to Step 3.
STEP 2A: MOUNT ON FLUE RISER OF RANGE
INSTALLATION
Figure 2