User's Manual

4
OPERATING INSTRUCTIONS
Mode Buon
Power Buon
• Pressing the power buon will turn ON or OFF the unit.
• When the unit is in ON mode, the power icon indicator light will be shown green.
• When the unit is in OFF mode, the power icon indicator light will be shown red. When power OFF, unit will be
stopped, if heater is working before power OFF the unit, fan will have 20 seconds delay to ensure heat will not
be trapped inside the unit.
Note: When plug the unit each me, 5 seconds fan and heater will turn on for internal check program.
Note: The unit has a memory funcon with last sengs for heang level and flame brightness effect, unless the
main power to the unit has been interrupted.
Temperature Seng
• The temperature mode controls the heater’s thermostat seng.
• Press UP Arrow Buon or Down Arrow Buon to scroll through the pre-set temperature range from 59°F (15°C)
to 86°F (30°C), ON & OF (OFF).
• Hold the mode buon for 3s, this allows the temperature unit changing from °C to °F or °F to °C. The unit
default is °F.
Note: This funcon is only available if using the control panel.
• When the ambient temperature is higher than the set temperature, heater will turn off automacally.
• Press the mode buon to cycle through the different funcons. Each me the mode buon is pressed, the
mode will enter the next funcon - Temperature, Timer or Flame Brightness.
Timer Seng
• The mer seng shoud be used to set the countdown for the unit’s main power.
• Press Up Arrow Buon or Down Arrow Buon to adjust the mer seng from 0 hour (OFF) to 9 hours with 0.5
hour interval.
Flame Brightness Seng
• The flame brightness mode should be used to set the flame brightness.
• Use Up arrow buon or Down arrow buon to scroll through the flame brightness sengs:
F0 (Flame OFF, only lowest brightest on ember bed), F1, F2, F3, F4, F5 (brightest).