User's Manual

5 HOMEDEPOT.COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance.
Installation - Surface Mounting Only
1
Drilling Hole on wall
WARNING: If installing the mirror on drywall or
other hollow wall applications, the Phillips head
screws (BB) must be fastened to studs, headers, or
other structural wall members. The included plastic
wall anchors are intended for use with solid wall
applications only (tile or concrete). DO NOT USE WITH
DRYWALL OR OTHER HOLLOW WALL APPLICATIONS.
□ The center distance of the two drilling holes on wall:
469.3mm (18.5 inches).
□ Insert the plastic wall anchors into the
holes and then tighten the screws to them.
18.5in
469.30mm
2
Electric Wire Connection
WARNING: This unit must be installed by a certied
electrician and in accordance with all local and national
electrical codes.
□ 1. Loosen 1 Screw to remove the wiring compartment
cover.
□ 2. Use screw driver to break off one of the knockouts from
the wiring compartment cover so as to form one hole to let
power supply wires to pass through.
NOTE: It is only necessary to remove the knockout(s)
that will feed the power supply wiring, keeping in mind the
mirror mounting location and supply wire location..
□ 3. Connect power supply wires to the wires of this unit
with wire connectors (CC) - black (Live wire) and white
(neutral). Ground wire should be secured to the green wire
OR yellow-green wire.
□ 4. Replace the wiring compartment cover and replace with
the 1 Screw.
Wires of the LED Mirror
Wiring Compartment
Cover
Knockout
Screw
Black
Mirror
Wire Nut
Connect
Wiring Diagram
Live
Neutral
Power Source
120V AC 60Hz
Ground
White
Green