INFRARED HEATING SYSTEM OWNER’S MANUAL Model No.
WARNING: READ THIS ENTIRE OWNER’S MANUAL CAREFULLY BEFORE USE. Thank you for choosing an SGH Infrared Zone Heating System. This owner’s manual will provide you with valuable information necessary for the proper care and maintenance of your new product. Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new heater.
IMPORTANT SAFETY INSTRUCTIONS READ AND UNDERSTAND ALL INSTRUCTIONS, SAFETY WARNINGS, AND FAQ’s BEFORE USING THE HEATER WARNING! ! POTENTIAL FOR ELECTRICAL HAZARD IF NOT ADHERED TO! When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. This heater must be plugged into a 120V, 15 amp (or more) circuit of its own. Nothing else can be plugged into the same circuit.
8. Do not use outdoors. Exposure to outdoor elements such as rain, snow, sun, wind or extreme temperatures may cause the heater to become a safety hazard. 9. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations, nor any locations that use GFCI outlets. 10. Never place heater where it may fall into a bathtub or other water receptacles. 11. Do not run cord under carpet. Do not cover cord with throw rugs, runners, or similar coverings.
FREQUENTLY ASKED QUESTIONS (FAQ’S) My heater emits a “strange” odor when I first open the box/when I turn the heater on for the first time. Why? These are both normal. This heater is treated with a special heat safe/resistant coating. This odor will sometimes be present when the box is opened, and may be compared to a heaters version of “new car smell.” Also, similar to all hearth appliances (woodstoves, etc.
I don’t have a grounded outlet; can I use adapters, a 2-prong power strip, or remove the ground prong from the cord? Definitely NOT! If you don’t have a grounded outlet, contact a certified electrician for advice. Removing or altering any part of the heater’s original design or intent (including the power cord) will not only void the warranty, but will make you liable for any unexpected or hazardous results.
I want to make sure my warranty is registered. What do I send to make sure it is registered? Where do I send it? The heater comes with an automatic 1 year limited manufacturer’s warranty at the time of purchase. Your receipt is considered your proof of purchase and registration. Keep it in a safe place. As long as it is legible, a copy may be used for any future warranty claims (if requested). If you have access to e-mail, and would like peace of mind, e-mail us to: Warranty@sourcegreenheat.com.
SPECIFICATIONS Voltage Rating 120 V (60Hz) Power Consumption 1500W Unit Size 13.1 in. (W) x 16.5 in. (D) x 17.7 in. (H) Unit Weight 26.9 lbs SAFETY FEATURES Tip-Over Safety Feature This heater is equipped with a tip-over safety feature. Once the heater is tipped over, an internal switch will automatically shut the heater off. Once the heater is restored an upright position, the heater will reset.
IN THE BOX INFRARED ZONE HEATING SYSTEM REMOTE CONTROL REMOTE CONTROL BATTERY INSTRUCTION BOOKLET PRODUCT DIAGRAM Remote Control Air Outlet Front Panel Control Panel Wheels Control Panel (Ref Fig. 1 next page) 1. Remote control signal sensor 2. Digital display: Indicates set desired room temperature 3. Power indicator light: Indicates that the heater is receiving power from outlet. Will flash when powered “ON’ 4. ON/OFF button: Powers the display on and off 5.
Fig. 1 1 15 2 14 13 3 4 12 11 10 9 8 7 6 5 Remote Control Mode button: Used for mode selection Power Mode ON/OFF button: Powers the display on and off Temp up button: To increase desired temperature Temp. Up Temp down button: To decrease desired temperature Temp.
PREPARATION Only operate heater in upright position with caster wheels attached. Place the heater on a firm, level surface. Plug into a grounded 120V (15 amp minimum dedicated circuit) 60Hz power outlet and the power toggle on the rear of the unit to the “ON” position. When using remote control, please pull out the insulating film as the following steps indicate.
OPERATING INSTRUCTIONS 1. Power the Display On/Off and Select Desired Mode Turn the heater on by pressing the ON/OFF button on the control panel or by pressing the Power button on the supplied remote control. Turn the heater off by pressing the ON/OFF button on the control panel or by pressing the Power button on the supplied remote control. Or Note: Powering off the heater will stop the heating process only.
3. Setting the POWER OFF TIMER Function Note: The Power-Off-Timer Function will allow for the heater to power OFF after a certain set time, and can only be set while the heater’s display is in the “On” position. Turn the heater to the “On” position. Press the Timer button on the heater’s control panel or the remote. Or The digital display changes from the “temperature” to the “hours” option for the timer.
5. Setting Electro Lock The Electro Lock can help avoid the heater from being accidentally engaged by children. The locking mechanism can be set in both the ON and OFF modes. And And Press Temp Up and Temp Down buttons at the same time for 3 seconds. Locking is complete when you hear a beep. When locked, the functions of the control panel and remote will be locked for use. When you need to unlock it, press Temp Up and Temp Down buttons at the same time for 3 seconds. You will hear a beep.
MAINTENANCE 1. Unplug the unit and let it cool completely. 2. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth. CAUTION: DO NOT let liquid enter the heater. 3. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This may cause damage or deterioration to the surface of the heater. 4. DO NOT immerse the heater in water. 5.
STORAGE Store the heater in a cool, dry location when not in use. To prevent dust and dirt build-up, use the original packaging to repack the unit. BASIC TROUBLESHOOTING If the heater will not operate, please check the following before seeking repair advice: 1. Check if the power cord is plugged into an electrical outlet, if not, plug in. 2. Check if power to the main power switch (in the back) is working. 3.
Limited Manufacturer Warranty 1 Year Limited Warranty: SGH warrants this heater against defects in materials and workmanship on functional parts, for a period of one year from the original date of purchase. Your sales receipt showing the date of purchase of the product is your proof of purchase. Keep it in a safe place for future reference.
Warranty Limitations This warranty does not apply if the unit has been subject to negligence, fabrication, misuse, abuse, or repairs (unless authorized verbally, or in writing, by an Authorized SGH Representative) alteration by non SGH authorized personnel, inappropriate installations, or any case beyond the control of SGH.
Customer Service and Support To Obtain Warranty Support or Advice, Please Complete These Two Easy Steps: Contact SGH PRODUCTS Technical Support E-mail: Warranty@sourcegreenheat.com Phone: 1-866-484-2066 You will need to provide the unit's model number, serial number (located on the heater’s front panel, rear panel, or on the box), date of purchase, retailer of purchase, a daytime phone number, and possibly a copy of your receipt. Be Patient, Clear, and Concise.
