Manual

In Backpage mode, the first four columns of the display are used to edit
four different parameters. Each parameter is denoted by a two letter ab-
breviation. They are as follows:
OE – Octave Extension: This parameter allows an 8th band to be added
to the equalizer, the 8th band is at a frequency of 62 Hz, one octave below
the normal low of 125 Hz. This frequency is especially helpful for use with
bass. The lowest position on the display indicates this features is off. The
next LED position up from the bottom indicates the octave extension is
enabled. After exiting backpage mode, the 62 Hz band can be accessed by
pressing the left band select button until the 125 Hz column is selected.
Pressing the left button again will shift the display and allow the 62 Hz
band to be displayed and edited by the encoder. Press the right band
select button to resume the normal 7-band view.
SW – Switching speed: This parameter controls scrolling speed when
using the footswitch to scroll through presets or using the auto-scroll
mode (see below). The full range of the display is used for this parameter.
Slowest speed is at the bottom and fastest at the top.
8 | Backpage Parameters
125 250 500 1K 2K 4K 8K
+18
-18
0
+18
-18
0
1 2 3 4
SAVE SELECT
OUTPUT
ON/OFF
(HOLD)
PRESET SELECT
62 125 250 500 1K 2K 4K
PROGRAMMABLE EQ
OE
SW MCAS
125 250 500 1K 2K 4K 8K
+18
-18
0
+18
-18
0
1 2 3 4
SAVE SELECT
OUTPUT
ON/OFF
(HOLD)
PRESET SELECT
62 125 250 500 1K 2K 4K
PROGRAMMABLE EQ
OE
SW
MCAS
PRESS
Off
Enabled
Slow
Fast