User Manual

14 | Controls: Footswitches
CONTROLS: FOOTSWITCHES
There are two footswitches on the Orbital Modulator. The left footswitch
corresponds to preset 1 and the right footswitch corresponds to preset
2. Pressing either of the footswitches will engage the respective preset.
Pressing the same footswitch again will put the effect back into bypass
mode. Pressing the other footswitch will engage the other preset without
going into bypass. The illumination of the LEDs labeled “1” and “2”
indicate which preset is currently enabled. While the effect is in bypass
mode both LEDs remain off.
When a preset is enabled and any sort of adjustment is made, the
indicator LED for that preset will begin to blink, showing that the preset
has been edited. After a preset has been edited, save it by pressing and
holding either footswitch. The corresponding LED will blink quickly to
indicate that the preset has been saved. Once changes are saved, the LED
will illuminate continuously. An edited preset can be saved to either of
the two preset locations. For example if preset 1 has been selected and
edited, it can be saved to preset location 2 by pressing and holding the
right footswitch.
Note: Changes made to a preset will be lost if you go into bypass or
switch to another preset without saving.