Owner's manual

Controls: Knobs | 11
OUTPUT
Adjusts the output level of the effect. This is useful for setting the level
of the effect compared to the bypass signal. Note that because the effect
compresses the signal, the dynamic range of the distorted signal will
be less compared to the dry signal. This should be accounted for when
setting levels.
TONE
The TONE knob along with the TONE SHAPE control will cut or boost the
Treble, Mid, or Bass frequencies depending on which mode is currently
selected. All three bands can be set to the default flat (no cut and no
boost) by pressing and holding the TONE SHAPE button.
Note: Since the Soundblox 2 Multiwave preset values can differ from the
physical knob positions, it can be useful to determine the positions of the
preset knob values. To do this, start with the pedal in bypass and set all of
the knobs to the full counter-clockwise position. Next, enable the preset
and slowly turn each knob up one at a time until the preset indicator LED
begins to blink rapidly. When this happens, the current position of the
knob matches the saved value.
BOOSTCUT
TONE
OUTPUT