Instruction Manual

Controls: Footswitches | 13
CONTROLS: FOOTSWITCHES
There are two footswitches on the Soundblox 2 Multiwave Bass Distortion.
The left footswitch corresponds to preset 1 and the right footswitch cor-
responds to preset 2. Pressing either of the footswitches will engage the
respective preset. Pressing the same footswitch again will put the effect
back into bypass mode. Pressing the other footswitch will engage the
other preset without going into bypass. There are indicator LEDs for each
footswitch that show which preset is currently enabled or both LEDs will
be off when the effect is in bypass mode.
When a preset is enabled and edited, the indicator LED for that preset will
begin to blink occasionally to show that the preset has been edited. Once
a preset has been edited, it can be saved by pressing and holding the
footswitch. The LED will blink quickly to indicate that the preset has been
saved. Once changes are saved, the LED will be lit solidly again. See the
Preset Saving Details section for other saving options.
Note: Changes made to a preset will be lost if you go into bypass or
switch to another preset without saving.
An edited preset can be saved to either of the two preset locations. For
example if preset 1 has been selected and edited, it can be saved to pre-
set location 2 by pressing and holding the right footswitch.