User Manual
Table Of Contents
- Welcome
- Table of Contents
- Feature Overview
- Connecting the Pedal
- Connections
- Controls
- Controls (Bass)
- Theory of Operation
- Distortion Types
- Stereo Operation & Signal Routing
- Preset Storage and Recall
- External Control
- Expression Control
- Neuro Desktop and Mobile Editors
- The Neuro Desktop Editor
- Sound Editor
- Master Controls
- Morphing Controls
- Compressor Module
- Distortion Module
- Multi-band Tremolo
- LFO Module
- Graphic Equalizer Module
- Single Tremolo/Envelope & Noise Gate/Input Filter Modules
- Envelope Generator, Balance, and Knob Assignment Modules
- The Neuro Mobile App — with New Direct MIDI-USB Support
- Neuro Hub
- MIDI
- USB
- Specifications
- Troubleshooting
- Frequently Asked Questions
- What kind of instruments can I connect to the Ultrawave’s inputs?
- Can I power the Ultrawave directly over USB, without using the 9 Volt supply?
- When connecting the Ultrawave to a recording interface or mixer, should I use a Lo-Z (microphone) or Hi-Z (line / instrument) input?
- Why doesn’t the Ultrawave respond to MIDI messages being sent to it?
- Can I use the Ultrawave in my amp’s effects loop?
- How do I update the firmware?
- Rubber Feet
- Waste Disposal Notes
- Warranty
- Version History
Table of Contents Ultrawave Multiband Processor User Guide
8
Controls
Note: The four top-level knob controls (Drive, Level, Sustain, and Treble) can be reassigned in the
Neuro Mobile App and Neuro Desktop Editor from a list of many possible parameters.
Footswitch
Click the footswitch to engage or bypass the pedal. Press and hold the footswitch down while the
pedal is bypassed to bank to Red LED (ALT) Mode for more presets.
Control Input / ALT Button
This small button located at the top of the pedal is used to enable or disable external control. It also
is used to control the ALT parameters on the surface of the pedal. Press and release the ALT button;
while the Control LED is flashing, turning the SUSTAIN or TREBLE knobs will access their alternate
parameters, Bass level and Mid level.
ON/OFF LED
The ON/OFF LED indicates whether the effect is bypassed or engaged. In ALT Mode, the LED
becomes red.
DRIVE Knob
Adjusts the distortion level. Turn clockwise for more distortion and saturation, or turn
counterclockwise for cleaner sounds.