User Manual
Table Of Contents
- Welcome
- Table of Contents
- Feature Overview
- Connecting the Pedal
- Connections
- Controls
- Controls (Bass)
- Theory of Operation
- Distortion Types
- Stereo Operation & Signal Routing
- Preset Storage and Recall
- External Control
- Expression Control
- Neuro Desktop and Mobile Editors
- The Neuro Desktop Editor
- Sound Editor
- Master Controls
- Morphing Controls
- Compressor Module
- Distortion Module
- Multi-band Tremolo
- LFO Module
- Graphic Equalizer Module
- Single Tremolo/Envelope & Noise Gate/Input Filter Modules
- Envelope Generator, Balance, and Knob Assignment Modules
- The Neuro Mobile App — with New Direct MIDI-USB Support
- Neuro Hub
- MIDI
- USB
- Specifications
- Troubleshooting
- Frequently Asked Questions
- What kind of instruments can I connect to the Ultrawave’s inputs?
- Can I power the Ultrawave directly over USB, without using the 9 Volt supply?
- When connecting the Ultrawave to a recording interface or mixer, should I use a Lo-Z (microphone) or Hi-Z (line / instrument) input?
- Why doesn’t the Ultrawave respond to MIDI messages being sent to it?
- Can I use the Ultrawave in my amp’s effects loop?
- How do I update the firmware?
- Rubber Feet
- Waste Disposal Notes
- Warranty
- Version History
Table of Contents Ultrawave Multiband Processor User Guide
17
Additional Routing Modes
The Ultrawave supports two additional routing modes, Cascade Ch.1 -> Ch. 2 and Mono -> Stereo ->
Mono available in the Neuro Mobile App and the Neuro Desktop Editor. View the routing modes
below to find out how you can configure the Ultrawave’s inputs, outputs and dual channels using a
Neuro connection.
Cascade Ch. 1 -> Ch. 2
This routing mode allows you to run both channels in series, meaning Channel 1 will cascade into
Channel 2. This is a very useful routing mode in terms of tone shaping and drive-stacking. When Ch.
1 and Ch. 2 are linked, the processing will be the same for both channels. When they are unlinked,
you can configure separate parameters for Channel 2.