User Manual
Table Of Contents
- Welcome
- Overview
- Quick Start
- Connections
- Basic Fuzz Operation
- Effect Types
- Controls
- Preset Storage and Recall
- Universal Bypass TM
- Stacking and Parallel Processing “Inside the Box”
- Stereo Routing
- Parametric EQ
- Low Cut Filter
- LoRetain
- Voice Control
- Noise Gate
- External Control
- Neuro App
- Specifications
- Troubleshooting
- Frequently Asked Questions
- How do I change the routing mode for my pedal without changing anything about the sounds?
- What kind of instruments can I connect to the Kingmaker’s inputs?
- Can I power the Kingmaker directly over USB, without using the 9 Volt supply?
- When connecting the Kingmaker to a recording interface or mixer, should I used a Lo-Z (microphone) or Hi-Z (line / instrument) input?
- Why doesn’t the Kingmaker respond to MIDI messages being sent to it?
- How do I enable extended effect types via MIDI?
- Rubber Feet
- Waste Disposal Notes
- Warranty
- Version History
SA245 Kingmaker Fuzz User’s Guide 21
6. Move the knob(s) you wish to control with the expression pedal to the minimum desired
position, then click the ON/OFF FOOTSWITCH. The CONTROL LED will now be lit solid red.
7. After setting the minimum and maximum knob positions, the parameter mapping is
complete.
Hot Hand Input
The Hot Hand 3 Wireless Effects Controller can be connected directly to the Kingmaker’s CONTROL
INPUT for motion control of the Kingmaker’s effects parameters. The Hot Hand has two axes of
expression: X and Y. These signal are carried on the two rings of the TRRS cable that comes from the
Hot Hand receiver.
Configuring the Hot Hand
When the Hot Hand is connected to the Kingmaker, follow these simple steps to calibrate it and map
it to control different effect parameters.
1. Press the CONTROL INPUT BUTTON to turn on Control Input mode. The CONTROL LED should be
lit green.
2. Press and hold the CONTROL INPUT BUTTON until the CONTROL LED begins to blink slowly
(approximately one blink per second).
3. Move the Hot Hand ring over the range of motion you would like to use to control the
Kingmaker. The easiest way to do this is to move the ring in the same way that you intend to
move it as you perform. The Kingmaker will intelligently select the X or Y axis of the Hot
Hand automatically, based on the motion of the ring.
4. After setting Hot Hand range of motion, click the Kingmaker’s ON/OFF FOOTSWITCH once. The
calibration is now complete, and the CONTROL LED will blink faster (about 2 blinks per
second). Now, it is time to map the Hot Hand to the effect parameters.
5. Move the knob(s) you wish to control with the Hot Hand to their minimum desired position,
then click the Kingmaker’s ON/OFF FOOTSWITCH. The CONTROL LED will now blink even faster
(about 4 blinks per second). Note that you may control one or more knobs with the Hot
Hand, up to four total knobs.
6. Move the knob(s) you wish to control with the Hot Hand to their maximum desired position,
then click the Kingmaker’s ON/OFF FOOTSWITCH. The CONTROL LED will now be lit solid green.
Note that you may control one or more knobs with the Hot Hand, up to four total knobs.
7. After setting the minimum and maximum knob positions, the parameter mapping is
complete.
Ground Power
Y Exp X Exp