User Manual
Table Of Contents
- Welcome
- Overview
- Quick Start
- Connections
- Basic Fuzz Operation
- Effect Types
- Controls
- Preset Storage and Recall
- Universal Bypass TM
- Stacking and Parallel Processing “Inside the Box”
- Stereo Routing
- Parametric EQ
- Low Cut Filter
- LoRetain
- Voice Control
- Noise Gate
- External Control
- Neuro App
- Specifications
- Troubleshooting
- Frequently Asked Questions
- How do I change the routing mode for my pedal without changing anything about the sounds?
- What kind of instruments can I connect to the Kingmaker’s inputs?
- Can I power the Kingmaker directly over USB, without using the 9 Volt supply?
- When connecting the Kingmaker to a recording interface or mixer, should I used a Lo-Z (microphone) or Hi-Z (line / instrument) input?
- Why doesn’t the Kingmaker respond to MIDI messages being sent to it?
- How do I enable extended effect types via MIDI?
- Rubber Feet
- Waste Disposal Notes
- Warranty
- Version History
SA245 Kingmaker Fuzz User’s Guide 20
Note that you can create “dead zones,” if desired, by only moving the expression pedal over
a limited region of its full range of motion.
4. After setting the expression pedal range, click the Kingmaker’s footswitch once. The
calibration is now complete, and the CONTROL LED will blink faster (about 2 blinks per
second). Now, it is time to map the expression pedal to the effect parameters.
5. Move the knob(s) you wish to control with the expression pedal to the minimum desired
position, then click the Kingmaker’s footswitch. The CONTROL LED will now blink even faster
(about 4 blinks per second). Note that you may control one or more knobs with the
expression pedal, up to four total knobs.
6. Move the knob(s) you wish to control with the expression pedal to their maximum desired
position, then click the footswitch. The CONTROL LED will now be lit solid green. Note that
you may control one or more knobs with the expression pedal, up to four total knobs.
7. After setting the minimum and maximum knob positions, the parameter mapping is
complete.
Note: The parameter range can be inverted by swapping the minimum and maximum position of the
knobs during configuration.
External Switch used as Expression Input (Expression “Toggle”)
An external switch can also work as a sort of expression pedal that only has two positions: on and off.
The external switch can be either momentary or latching.
To use this mode, connect an external switch to CONTROL INPUT. The following plug configuration is
required:
Follow these steps for configuration:
1. Press the CONTROL INPUT BUTTON to enable external control. The CONTROL LED should be lit red.
2. Press and hold the CONTROL INPUT BUTTON until the CONTROL LED begins to blink slowly
(approximately one blink per second).
3. Tap the external switch once.
4. Click the ON/OFF FOOTSWITCH once. The CONTROL LED will blink faster (about 2 blinks per
second). Now, it is time to map the external switch to the effect parameters.
5. Move the knob(s) you wish to control with the external switch to the maximum desired
position, then click the ON/OFF FOOTSWITCH. The CONTROL LED will now blink even faster
(about 4 blinks per second). Note that you may control one or more knobs with the external
switch, up to six total knobs.
Ground Switch Out
Power (Switch pull-up)
1/8” (3.5mm)