User Manual

SA242 Gemini Chorus User’s Guide 34
How do I enable extended effect types via MIDI?
Refer to the MIDI Learn section to map a MIDI continuous controller to the Effect Type switch. Then,
send a CC message with one of the following values to enable a certain effect type:
CC Value
Effect Type
0
Classic Flange/Chorus
1
Shadow
2
Thru-Zero
3
Resonator 1
4
Resonator 2
5
Dual Chorus
6
Quad Chorus
7
Vibe
8
4 Stage Phaser
9
6 Stage Phaser
10
8 Stage Phaser
11
12 Stage Phaser
Additional effect types may become available in future updates.
Can I use the Gemini in my amp’s effects loop?
The audio inputs can handle up to 8.2 dBu or 5.6 Volts peak-to-peak, which allows them to work in
most amp effects loops. In order to avoid clipping, be sure to check your amp’s documentation and
verify that the maximum send level is less than 5.6 Volts peak-to-peak.
Rubber Feet
The Gemini comes standard with a flat aluminum bottom, making it easy to apply Velcro and mount
to a pedalboard. Additionally, adhesive rubber feet are included in the Gemini’s box. Applying the
rubber feet to the Gemini can help prevent it from sliding on flat surfaces such as a hardwood floor.
Waste Disposal Notes
If possible, dispose of the device at an electronics recycling center. Do not dispose of the device with
the household waste.
For full compliance with EN 61000-4-6 standard, input cable must be less than 3 meters in length.