User Manual

ManualsBrandsSource Audio ManualsChorus - FlangerMercury Flanger - STEREO PEDAL FLANGER EFFECT FOR GUITAR

Table Of Contents

Welcome
Overview
Quick Start
- Power
- Guitar/Audio Connections
- Brief Knob, Footswitch, and Button Descriptions
Connections
- Input Side Connections
  - Input 1
  - Input 2
    - Input 2 as an Audio Input
    - Input 2 as a Neuro App Data Input
- Output Side Connections
  - Output 1
  - Output 2
    - Output 2 as an Audio Output
    - Output 2 as a Neuro App Data Daisy-Chain Output
- Example Neuro Daisy-Chain Connections
  - Mono Audio Path with Neuro Daisy-Chain
  - Mono-To-Stereo Audio Path with Neuro Daisy-Chain
- Power and Control Connections
Basic Flanger Operation
Effect Types
- Classic
- Thru-Zero
- Shadow
- Additional Effect Types
Controls
- Knobs
- Effect Switch
- LEDs
  - Engage / Bypass LED
  - External Control LED
- Footswitch
- Control Input Button
Preset Storage and Recall
- Saving Your First Preset
- Editing a Preset
- Exiting Preset Mode
- Quick Preset Switching
Universal Bypass TM
Stereo Routing
Parametric EQ
- Low Cut Filter
External Control
- Expression Control
Neuro App
- Main Menu
- Sound Editor
- Browse Sounds
  - Open In Sound Editor
  - Deleting or Publishing Presets
- Hardware Options
- Neuro Hub (Formerly the Soundblox Hub)
  - MIDI
- USB
  - USB-MIDI
- External Tap Tempo
Specifications
- Dimensions
- Weight
- Power
- Audio Performance
Troubleshooting
- General
  - Factory Reset using the Neuro App
  - Factory Reset using the Hardware (Firmware v1.06 and later)
- Noise
- Hot Hand Doesn’t Work
- Unit Appears Dead / No LEDs Lit
Frequently Asked Questions
- How do I change the routing mode for my pedal without changing anything about the sounds?
- What kind of instruments can I connect to the Mercury’s inputs?
- Can I power the Mercury directly over USB, without using the 9 Volt supply?
- When connecting the Mercury to a recording interface or mixer, should I used a Lo-Z (microphone) or Hi-Z (line / instrument) input?
- Why doesn’t the Mercury respond to MIDI messages being sent to it?
- How do I enable extended effect types via MIDI?
- Can I use the Mercury in my amp’s effects loop?
Rubber Feet
Waste Disposal Notes
Warranty
- Limited Transferrable Warranty
- Warranty Information
- Disclaimer and Limitation of Warranty
Version History

SA240 Mercury Flanger User’s Guide 34

App. Channel numbers in MIDI use zero-based counting, so MIDI channel 1 is described as 0 in

hexadecimal, MIDI channel 2 is described as 1 in hexadecimal, and so on, concluding with MIDI

channel 16, which is described as F in hexadecimal. A continuous controller message starts with a

hexadecimal B and is followed by the channel number (0 through F). So, the command byte from

your MIDI controller should be formatted as shown in the following table:

MIDI Channel

(Decimal)

CC Command Byte

(Hex)

Each continuous controller command byte is followed by two bytes, the CC number and the value. So,

each CC message consists of a total of three bytes. If the Mercury is not responding to MIDI, make

sure that your MIDI controller is properly configured and sending messages in the format described

above.