User Manual
Table Of Contents
- Welcome
- Overview
- Quick Start
- Connections
- Basic Flanger Operation
- Effect Types
- Controls
- Preset Storage and Recall
- Universal Bypass TM
- Stereo Routing
- Parametric EQ
- External Control
- Neuro App
- Specifications
- Troubleshooting
- Frequently Asked Questions
- How do I change the routing mode for my pedal without changing anything about the sounds?
- What kind of instruments can I connect to the Mercury’s inputs?
- Can I power the Mercury directly over USB, without using the 9 Volt supply?
- When connecting the Mercury to a recording interface or mixer, should I used a Lo-Z (microphone) or Hi-Z (line / instrument) input?
- Why doesn’t the Mercury respond to MIDI messages being sent to it?
- How do I enable extended effect types via MIDI?
- Can I use the Mercury in my amp’s effects loop?
- Rubber Feet
- Waste Disposal Notes
- Warranty
- Version History
SA240 Mercury Flanger User’s Guide 25
Burn
The Burn command takes the current sound that is running in the hardware and “burns” it to the
internal memory for later use. Burn works as a “what you hear is what you get” type of control; it will
save all of the settings in their current state, as you hear them, and put those into memory. This will
not necessarily match the exact settings shown in the Sound Editor for all parameters unless you
have performed a Send All command first.
After selecting the Burn command, a list of target locations in memory is displayed. There are a total
of 4 options: the 3 factory slots that correspond to the effect selector switch, and the 1 slot in preset
memory.
Replacing an Effect on the Effect Switch
It is possible to replace one of the main effect types with one of the extended effect types or with a
user-created sound. To do this, follow these steps:
Load the sound in the Sound Editor.
Hit the Send All button.
Hit the Burn button.
Select one of the Effect Selector Switch positions to overwrite it.