User Manual
Table Of Contents
- Welcome
- Overview
- Quick Start
- Connections
- Basic Overdrive Operation
- Effect Types
- Controls
- Preset Storage and Recall
- Universal Bypass TM
- Stacking and Parallel Processing “Inside the Box”
- Stereo Routing
- Parametric EQ
- Low Cut Filter
- LoRetain
- Voice Control
- Noise Gate
- External Control
- Neuro App
- Specifications
- Troubleshooting
- Frequently Asked Questions
- How do I change the routing mode for my pedal without changing anything about the sounds?
- What kind of instruments can I connect to the L.A. Lady’s inputs?
- Can I power the L.A. Lady directly over USB, without using the 9 Volt supply?
- When connecting the L.A. Lady to a recording interface or mixer, should I used a Lo-Z (microphone) or Hi-Z (line / instrument) input?
- Why doesn’t the L.A. Lady respond to MIDI messages being sent to it?
- How do I enable extended effect types via MIDI?
- Rubber Feet
- Waste Disposal Notes
- Warranty
- Version History
SA244 L.A. Lady Overdrive User’s Guide 21
Follow these steps for configuration:
1. Press the CONTROL INPUT BUTTON to enable external control. The CONTROL LED should be lit red.
2. Press and hold the CONTROL INPUT BUTTON until the CONTROL LED begins to blink slowly
(approximately one blink per second).
3. Tap the external switch once.
4. Click the ON/OFF FOOTSWITCH once. The CONTROL LED will blink faster (about 2 blinks per
second). Now, it is time to map the external switch to the effect parameters.
5. Move the knob(s) you wish to control with the external switch to the maximum desired
position, then click the ON/OFF FOOTSWITCH. The CONTROL LED will now blink even faster
(about 4 blinks per second). Note that you may control one or more knobs with the external
switch, up to six total knobs.
6. Move the knob(s) you wish to control with the expression pedal to the minimum desired
position, then click the ON/OFF FOOTSWITCH. The CONTROL LED will now be lit solid red.
7. After setting the minimum and maximum knob positions, the parameter mapping is
complete.
Hot Hand Input
The Hot Hand 3 Wireless Effects Controller can be connected directly to the L.A. Lady’s CONTROL INPUT
for motion control of the L.A. Lady’s effects parameters. The Hot Hand has two axes of expression: X
and Y. These signal are carried on the two rings of the TRRS cable that comes from the Hot Hand
receiver.
Configuring the Hot Hand
When the Hot Hand is connected to the L.A. Lady, follow these simple steps to calibrate it and map it
to control different effect parameters.
Ground Switch Out
Power (Switch pull-up)
1/8” (3.5mm)
Ground Power
Y Exp X Exp