User Manual
Table Of Contents
- Welcome
- Overview
- Quick Start
- Connections
- Basic Phaser Operation
- Effect Types
- Controls
- Preset Storage and Recall
- Universal Bypass TM
- Stereo Routing
- Parametric EQ
- External Control
- Neuro App
- Specifications
- Troubleshooting
- Frequently Asked Questions
- How do I change the routing mode for my pedal without changing anything about the sounds?
- What kind of instruments can I connect to the Lunar’s inputs?
- Can I power the Lunar directly over USB, without using the 9 Volt supply?
- When connecting the Lunar to a recording interface or mixer, should I used a Lo-Z (microphone) or Hi-Z (line / instrument) input?
- Why doesn’t the Lunar respond to MIDI messages being sent to it?
- How do I enable extended effect types via MIDI?
- Can I use the Lunar in my amp’s effects loop?
- Rubber Feet
- Waste Disposal Notes
- Warranty
- Version History
SA241 Lunar Phaser User’s Guide 5
Connections
Input Side Connections
Input 1
This is the primary input for guitar, bass, or other instruments. It can also accept line-level inputs.
Connect it to your instrument or other audio source using a mono (TS) ¼” cable.
Input 2
Input 2 can act either as an audio input or as the data connection for the Neuro App, or both at the
same time.
Input 2 as an Audio Input
The tip contact on Input 2 acts as a secondary input for guitar, bass, or other instruments. It is only
active when the Lunar is configured with a signal routing that uses stereo inputs. Connect it to your
instrument (or the previous effect in the signal chain) using a mono (TS) ¼” cable. By default, the
Lunar will auto-detect the routing mode. Other routing options are available using the Neuro App.
For more information about stereo routing, refer to the Stereo Routing section.
Input 2 as a Neuro App Data Input
The ring contact on Input 2 acts as a data connection for the Neuro App. Connect it to your mobile
device using a stereo (TRS) ¼” cable. It can also accept daisy-chained Neuro data from another
Neuro-compatible pedal in the chain, provided that a TRS cable is used. The audio signal (if
applicable) will be on the tip contact of the plug, and the Neuro App data will be on the ring contact.
Input 2 only accepts data from the Neuro App. Data from the Neuro Hub comes from the Control
Input port.