User Manual
Table Of Contents
- Welcome
- Overview
- Quick Start
- Connections
- Delay Engines
- Extended Delay Engines
- Controls
- Preset Storage and Recall
- Universal Bypass
- Stereo Operation
- External Control
- Neuro App
- Neuro Hub
- MIDI
- USB
- Specifications
- Troubleshooting
- Frequently Asked Questions
- What kind of instruments can I connect to the Nemesis’s inputs?
- Can I power the Nemesis directly over USB, without using the 9 Volt supply?
- When connecting the Nemesis to a recording interface or mixer, should I used a Lo-Z (microphone) or Hi-Z (line / instrument) input?
- Why doesn’t the Nemesis respond to MIDI messages being sent to it?
- Can I use the Nemesis in my amp’s effects loop?
- MIDI Implementation
- Rubber Feet
- Waste Disposal Notes
- Warranty
- Version History
SA260 Nemesis Delay User’s Guide 32
3. Tap the external switch once.
4. Click the ON/OFF FOOTSWITCH once. The CONTROL LED will blink faster (about 2 blinks per
second). Now, it is time to map the external switch to the effect parameters.
5. Move the knob(s) you wish to control with the external switch to the maximum desired
position, then click the ON/OFF FOOTSWITCH. The CONTROL LED will now blink even faster
(about 4 blinks per second). Note that you may control one or more knobs with the external
switch, up to six total knobs.
6. Move the knob(s) you wish to control with the expression pedal to the minimum desired
position, then click the ON/OFF FOOTSWITCH. The CONTROL LED will now be lit solid red.
7. After setting the minimum and maximum knob positions, the parameter mapping is
complete.
Expression Toggle Connected to Control Input
To use this mode, connect an external switch to CONTROL INPUT and set the PEDAL IN SWITCH to the
SWITCH position instead of the EXP position. The following plug configuration is required:
Follow these steps for configuration:
1. Press the CONTROL INPUT BUTTON to enable external control. The CONTROL LED should be lit red.
2. Press and hold the CONTROL INPUT BUTTON until the CONTROL LED begins to blink slowly
(approximately one blink per second).
3. Tap the external switch once.
4. Click the ON/OFF FOOTSWITCH once. The CONTROL LED will blink faster (about 2 blinks per
second). Now, it is time to map the external switch to the effect parameters.
5. Move the knob(s) you wish to control with the external switch to the maximum desired
position, then click the ON/OFF FOOTSWITCH. The CONTROL LED will now blink even faster
(about 4 blinks per second). Note that you may control one or more knobs with the external
switch, up to six total knobs.
6. Move the knob(s) you wish to control with the expression pedal to the minimum desired
position, then click the ON/OFF FOOTSWITCH. The CONTROL LED will now be lit solid red.
7. After setting the minimum and maximum knob positions, the parameter mapping is
complete.
Hot Hand Input
The Hot Hand 3 Wireless Effects Controller can be connected directly to the CONTROL INPUT jack for
wireless motion control of the Nemesis’s effects parameters. The Hot Hand has two axes of
Ground Switch Out
Power (Switch pull-up)
1/8” (3.5mm)