User Manual

| 23 External Control
MIDI CONTROL
The Manta can be controlled via generic MIDI messages. To access
MIDI functionality, the pedal requires the Source Audio Neuro Hub (sold
separately - please check www.sourceaudio.net for availability). The
Hub expands your connections to further the control of up to five
Soundblox2 or Ones Series pedals. The Hub has 5-pin MIDI DIN In and
Out jacks, a USB port, Sensor In (for Hot Hand) and a 1/4” expression
input.
Save up to 128 multi pedal presets (or “scenes”) complete with assigned
expression control. Easily recall complex presets with a single MIDI
program change messages. The Hub also receives MIDI clock or
continuous controller (CC) messages.
For more information on using your Soundblox 2 pedals with MIDI, and
for MIDI mappings, please visit our website at www.sourceaudio.net
USE WITH HOT HAND
All Soundblox pedals are compatible with our Hot Hand accessories. Hot
Hand units consist of a ring containing an accelerometer that detects motion
and controls effect parameters. To enable Hot Hand functionality, connect
the Hot Hand receiver or base station to the MULTI-FUNCTION IN and select
HH mode with the CONTROL INPUT button. The pedal will now accept input
signals from Hot Hand. Use these signals to control standard modulation or
the assigned parameter.
The MANTA can also be calibrated to change the center-point of the Hot
Hand control range. To do this, follow the calibration procedure below. Note
that calibration is only used for Hot Hand mode and calibration is NOT
required before use.