User Manual
Table Of Contents
- Welcome
- Contents
- Feature Overview
- Connecting the Pedal
- Connections
- Basic Operation
- The Options Menu
- Navigating the Options Menu
- Controls
- Common EQ Configurations
- Stereo Operation & Signal Routing
- Preset Storage and Recall
- Additional Features
- External Control
- Expression Control
- Neuro Desktop and Mobile Editors
- The Neuro Desktop Editor
- The Neuro Mobile App — with New Direct MIDI-USB Support
- Neuro Hub
- MIDI
- USB
- Specifications
- Troubleshooting
- Frequently Asked Questions
- What kind of instruments can I connect to the EQ2’s inputs?
- Can I power the EQ2 directly over USB, without using the 9 Volt supply?
- When connecting the EQ2 to a recording interface or mixer, should I use a Lo-Z (microphone) or Hi-Z (line / instrument) input?
- Why doesn’t the EQ2 respond to MIDI messages being sent to it?
- Can I use the EQ2 in my amp’s effects loop?
- How do I update the firmware?
- Rubber Feet
- Waste Disposal Notes
- Warranty
- Version History
SA270 EQ2 User Guide
19
Copying a Preset to a New Location Using the Select/(Hold) Save Button
1. Select the preset you would like to copy by pressing the SELECT Button until the corresponding
PRESET LED is lit.
2. Press and hold the SELECT Button for one second until the corresponding PRESET LED begins
blinking rapidly. Quickly release the SELECT Button. The PRESET LED should continue to blink
rapidly. This indicates that the EQ2 is in copy mode.
3. Tap the SELECT Button to increment the preset. The corresponding PRESET LED should continue
to blink rapidly. Tap the SELECT Button again until the desired copy destination is selected.
4. Press and hold the SELECT Button until the PRESET LED blinks slowly and then turns solid. This
indicates that the preset has been saved to the new location. The original location will not be
changed or overwritten.
Copying a Preset to a New Location Using an External MIDI Controller
1. Select the preset you would like to copy by sending a MIDI program change message to the
EQ2.
2. Press and hold the SELECT Button for one second until the corresponding PRESET LED begins
blinking rapidly. Quickly release the SELECT Button. The PRESET LED(S) should continue to blink
rapidly. This indicates that the EQ2 is in copy mode.
3. Send a desired MIDI Program Change number to indicate the desired copy destination for the
preset. The unit will show the preset LED changing, but it won’t actually recall that
preset. You’re just setting the address of where to copy.
4. Once the desired PC is sent, press and hold the select/save button again until you get a slow
blink. Preset has been copied to the new location.
Copying a Preset to a New Location Using the Neuro App
Using the BURN command in Neuro Mobile or Desktop Editors, it is possible to copy presets to any
location in memory.
Clearing all Presets
All 128 User Presets can be erased using the Factory Reset procedure. Warning: The Factory Reset
procedure resets the entire pedal back to the state in which it was originally shipped – this includes
all global settings and User Presets. A Factory Reset will not erase any firmware updates.
Additional Features
Along with complete equalization control and complex routing options, EQ2 packs a few more
features for the ultimate tone-shaping experience.
Noise Gate
Accessible by the Options menu (see Basic Operation for details on how to access), an optional noise
gate is available for reducing any noise from your signal up to a certain dB threshold. More noise
gate options are available in the Neuro App and Neuro Desktop Editor.