-TABLE - - OF-CONTENTS-- PLANNING & MOUNTING YOUR SYSTEM ------------------ 10 Amplifier's provide high-performance sound reinforcement for you're mobile audio equipment. The Multi-Mode bridging capabilities allow flexibility in hosting several different speaker configurations. To achieve optimum performance, it is highly recommended that you read this Owners Manual before beginning installation.
FEATURES - - - Controls-&- Functions - - - Digital Full range Amplifier Fully regulated MOSFET power supply PWM circuitry 2 Ohm stable stereo Tri-guard amplifier protection I D I (~intelligent Distresslndicator )gives a visual indication of the amplifiers protection status Platinum RCA inputs and outputs Bi-linear selectable crossover for inputs and outputs (HiIFulllLow) Continuously variable High pass filter : 50~z-250~fi12dBslopes) Continuously variable Low pass filter : 50Hz-250Hz (1 2dB slopes) Subwo
Controls-& Functions- . - . - Controls -& Functions .. -~ - . BASS BOOST I%i\ 0 +I268 PWR(Power):This GREEN LED will illuminate when the amplifier is turned "ON". If it fails to illuminate, check the power connections to the Amplifier and fuses. BY usina the bass boost function, bass notes at 50Hz are em~hasized as much as 12dB. I JJNE@.. LlNE OUT LlNE IN CH~,.'"' CHI PROT(h0tection):The amplifier protection circuitry will disable the amplifier if input overload.
Planning and Mounting Your System -Controls-&-Functions --- .--- The mounting position of your Amplifier wlll have a great effect on its ability to dissipate the heat generated during normal operation. Under normal conditions, the heatsink will dissipate sufficient heat to avoid thermal shutdown. However please do not install the amplifier in a wooden box or similar device as this will prevent heat dissipation into the atmosphere.
coo
_ _ _ Shooting Trouble _ _ _- - Tunina on the Am~lifier The amplifier automatically turns on within a few seconds after remote voltage Is applied. If your system is set-up so that the headunit provides the remote voltage; then it would turn on when your stere6 is turned on. Note that there are alternate means of providing the 12 volt remote control signal, including installing and auxiliary switch. SYMPTOMS CHECK 1s the power LED illuminated? (NO) Check all fuses to amplifier.
