DTA Automorwe Digital to Analog Processor OWNER’S MANUAL SOUNDSTREmAl’v’~ TECHNOLOGlES
DTA 1 Digital to analog Processor OWNER’S MANUAL Thank you for purchasing the Soundstream DTAl . You now own the finest automotive Digital to Analog processor made, a precision component with audiophile performance. For maximum performance, we suggest you take a few moments to read through this manual, to better acquaint yourself with the design features and capabilities of your new DTAl . This Soundstream product is the result of the combined efforts of Krell Digital and Soundstream Technologies.
CONNECTIONS l--l Wiring Layout In general, you should plan to connect the DTAl between the digital source and the control head unit, as shown in Figure 3. If you are using an equalizer or active crossover, be sure to insert the DTAl in the chain before any of these components. Determine how your vehicle’s wiring is laid out, and plan to run your new wiring along the same routes. Be sure to keep power wires away from all audio signal wires.
wires inside the vehicle, hidden from passengers. An exposed wire can inadvertently be pulled out, and may cause disconnection or shorting. location and Mounting The DTAl is compact in size and it generates virtually no heat. It can be located almost anywhere within the passenger compartment, trunk, or storage area. However, do not install the DTAl in the engine compartment or in any outside location exposed to dirt and moisture. Use the DTAl as a template to mark drill holes.
