D200 II DUAL MONAURAL AMPLIFIER CLASS A 100 PURE CLASS A AMPLIFIER DlOO II STEREO AMPLIFIER CLASS A 50 II PURE CLASS A AMPLIFIER D60 II STEREO AMPLIFIER Owner’s Manual
Soundstream Stereo Amplifier Owner’s Manual Thank you for purchasing a Soundstream amplifier. You now own one of the finest power amplifiers available, a precision instrument capable of audiophile quality performance. To get the most out of your amplifier, we suggest that you carefully acquaint yourself with their capabilities and design. Please retain this manual for future reference.
INSTALLATION The design topology of all Soundstream amplifiers utilize multiple Darlington output devices with a total rated output capability that far exceeds the potential output of the amplifier. The D200 II utilizes 1000 watts of discrete Darlington output devices while the DlOO II utilizes 500, the Class A 100 1000, the Class A 5011 500 and the D60 II uses 300 watts worth of discrete Darlingtons. With such reserves and no current limiting, these amplifiers operate without strain even at maximum output.
LOCATION AND MOUNTING The first step in an installation is thorough planning. Choose the location for your amplifier carefully, The amplifier should be located in either the passenger compartment or the trunk, never in the engine compartment or any outside location exposed to dirt or moisture. Adequate ventilation is important; allow enough space so that air can circulate around the heat sinks. Make sure the installed amplifier will not interfere with normal operation of the vehicle.
POWER CONNECTIONS Note: Your amplifier can only be operated from a 12Volt Negative Ground electrical system. If your car was produced before 1970, or if you have any doubts, make sure of the type of electrical system you have before making any connections. driver. Note: If an outboard switch is used, make sure it is switched off when you leave the vehicle or when the sound system is not in use otherwise it is possible to run down your battery.
PROTECTION CIRCUITS Your amplifier is protected against both overheating and short circuits. If one channel shuts down, check the speaker output fuse for that channel. If after replacing the fuse it blows again, contact Soundstream directly or your authorized Soundstream dealer If the amplifier shuts down completely, check the power supply fuse located behind the bottom cover of the amplifier. If this blows a second time, contact an authorized Soundstream dealer or Soundstream directly for service..
SPECIFICATIONS: D-6011 CA- 100 Power Output 30 W/ch X 2, 20Hz-20kHz Into 4Q 45 W/ch X 2, 20Hz-20kHz Into 2Q 80 Watts Mono, 20Hz-20kHz Into 452 Total Harmonic Distortion < O.l%, 20Hz-20kHz At Full Rated Power Into 4a S/N Ratio: 110 dB Damping Factor: >200 Input Impedance: 10 K Idle Current Draw: .2 Amps Maximum Current Draw: 7 Amps Dimensions: 4.3” W X 7.8” D X 2.13”H Input Sensitivity: 250 mV - 2.
