Owner's Manual

Truck

Door

Kit

Instructions

• I

Start by localing the fastening hardware

the

door

panel,

take

the appropriate screw driver

and

remove

Once

all

the

screws are removed

you

can

take off the

door panel gently watching that

you

don't break

any

the

cfips

or mounting hardware.

the

panel away slowly

and

unplug

any

electrical

connections.

PAGE 1
Truck Door Kit Instructions 1. Start by localing the fastening hardware on the door panel, take the appropriate screw driver and remove. 2. Once all the screws are removed you can take off the door panel gently watching that you don't break any of the cfips or mounting hardware. 3. Pull the panel away slowly and unplug any electrical connections.
PAGE 2
4. Now you are ready lo prep the metal surface using a miCfofiber cloth, Acetone (use a breathing mask), and wipe away any moisture, oil, debris or etc. Then let air dry for an appropriate time. The point is lo get the surface clean to ensure material glue contact. 5. When the surface is dry and clean, locate the piece of the kit with the label on lhe back that coincides with the door you' re working on. Make sure it lines up and is correct before you pull the while cover paper off.
PAGE 3
2019-2021 Recommended Installation Instructions 4 Piece Custom Cut PRO KIT A. Prepping the Surface After removing interior door panels you are ready to clean the metal areas that will be insulated. If the metal has “new” look without imperfections then take the microfiber cloth provided and wipe away any dust and debris. If the metal is showing signs of age like rust then we recommend using Acetone with a breathing mask to wipe off debris and loose particles.