Owner's Manual

4. Now you are ready to prep the metal surface
using a microfiber cloth, Acetone (use a breathing mask),
and wipe away any moisture, oil, debris or etc. Then let air
dry for an appropriate time. The point is to get the surface
clean to ensure material glue contact.
5. When the surface is dry and clean, locate the
piece of the kit with the label on the back that coincides
with the door you' re working on. Make sure it lines up and
is correct before you pull the white cover paper off. After
you confirm the right piece, pull off the white paper and
start placing the material at the top and work your way
down. Most important is that the material is pushed down
completey and that no air is trapped. Use a razor blade
point or household needle to release air. Repeat these
steps for all door panels.
6. Now you are ready to place the door panel back on your
door. All necessary openings will be available after you
have applied the Soundskins material. Secure door panel
with all screws and you are now ready to hit the road.
ENJOY!
Soundskins USA
13452 Alondra Blvd, Cerritos, Ca 90703
Phone.: [phone]
Email: [e-mail]
www.SoundSkinsGlobal.com