OMEGA-300 RGB Compact Graphic Laser System USER MANUAL Please read this manual carefully and proper take care of this manual.
Dear customer, First of all thanks for purchasing a SOUNDSATION® product. Our mission is to satisfy all possible needs of musical instrument, professional audio and lighting users offering a wide range of products using the latest technologies. We hope you will be satisfied with this item and, if you want to collaborate, we are looking for a feedback from you about the operation of the product and possible improvements to introduce in the next future. Go to our website www.soundsationmusic.
ENGLISH OMEGA-300 RGB User manual IMPORTANT SAFETY SYMBOLS The symbol is used to indicate that some hazardous live terminals are involved within this apparatus, even under the normal operating conditions, which may be sufficient to constitute the risk of electric shock or death. The symbol is used in the service documentation to indicate that specific component shall be replaced only by the component specified in that documentation for safety reasons.
ENGLISH OMEGA-300 RGB User manual ff This product is for laser show only. The class 3B laser light should be operated by professional operator only. ff This is so-called show laser, emitting radiation with a wavelength spectrum between 400 and 700nm and producing lighting effects for shows. ff International laser safety regulations require that the vertical height from installment to ground is more than 3 meters, horizontal distance is 2.5 meters from audience.
ENGLISH OMEGA-300 RGB User manual Condensation To avoid condensation to be formed inside, allow this unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. Heat The apparatus should be located away from heat sources such as radiators, stoves or other appliances that produce heat. Don not use it when maximum ambient temperature is higher than 40°C.
ENGLISH OMEGA-300 RGB User manual Cleaning Clean only with a dry cloth. Do not use any solvents such as benzene or alcohol. Servicing Do not implement any servicing other than those means described in the manual. Refer all servicing to qualified service personnel only. Only use accessories/attachments or parts recommended by the manufacturer. 1. 1. INTRODUCTION Thank you for purchasing our OMEGA-300 RGB graphic laser.
ENGLISH OMEGA-300 RGB User manual 2. OVERVIEW SOUNDSATION OMEGA-300 RGB is a new Class 3B professional graphic laser projector based on state-of-the-art technology. It features high-quality LED RGB laser emitters that produce bright laser beams and smooth patterns. LED panel menu, and the handy remote control make this fixture extremely easy to program and convenient to use.
ENGLISH OMEGA-300 RGB User manual • Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The fixture must be fixed at least 50cm from surrounding walls. • The device should be installed out of reach of people and outside areas where persons may walk by or be seated. • Before rigging, make sure that the installation area can hold minimum point load of 10 times the device”s weight.
ENGLISH OMEGA-300 RGB User manual 6. DMX CONNECTION DMX fixtures are designed to receive data through a serial Daisy Chain. A Daisy Chain connection is where the DATA OUT of one fixture connects to the DATA IN of the next fixture. The order in which the fixtures are connected is not important and has no effect on how a controller communicates to each fixture. Use an order that provides for the easiest and most direct cabling.
ENGLISH OMEGA-300 RGB User manual DMX Terminator 120ohm, 1/4W resistor Complimentary signal cable can transmits signals to 20 unit fixtures at most. Signal amplifier is a must to connect more fixtures. 6.2. 3-Pin vs 5-Pin DMX cables DMX connection protocols used by controllers and fixtures manufacturers are not standardized around the world. However, two are the most common standards: 5-Pin XLR and 3-Pin XLR system.
ENGLISH OMEGA-300 RGB User manual • Observe the place of image and light lens, then press ENTER to confirm and save. 8. FRONT/REAR PANELS 4 3 1 1. POWER: Main power indicating LED. Red is ON. 2. MUSIC: Synchronize to detected music signal. 3. IR: Infrared Remote Receiver. 4. Laser output: Laser output aperture. 2 10 8 SERIAL N.
ENGLISH OMEGA-300 RGB User manual 11. LED control interface: Various mode setting operation for machine 12. Mic: Turn the knob to adjust the sound activated sensitivity. 9. MENU OPERATING INSTRUCTION Once after every power on laser, VERSION and MANUFACTURE INFORMATION will be shown in LED display of rear panel. Once laser is powered on, the display monitors current operating standalone mode or DMX address of DMX mode. With this LED display, it is very easy to set and change operating mode of laser.
ENGLISH OMEGA-300 RGB User manual LED Display Function LED Display Function Aut Au1 Au2 Au3 Au4 Au5 Au6 Au7 Auto Aut 1 Aut 2 Aut 3 Aut4 Aut5 Aut6 Aut7 Sou So1 So2 So3 So4 So5 So6 So7 Sound Sound 1 Sound 2 Sound 3 Sound4 Sound5 Sound6 Sound7 Attention : In preprogrammed standalone SOUND mode, the laser beam will be blank-out in 3 seconds without AUDIO/MIC activated signal. 9.1.
ENGLISH OMEGA-300 RGB User manual 10. REMOTE CONTROLLER AUTO Shows MUISC Shows Laser NO/OFF Color Changing Effect Pause Mirror Func SOUND Sensitevity Fixed Pattern(32) Repeat playing Button Function ON/OFF AUTO MUSIC Sound Sensitivity 1 9 Description All modes other than the “slave” mode, continue to press”ON/OFF” in the remote control button for 2 seconds, you can enter or exit the remote mode.
ENGLISH OMEGA-300 RGB User manual 11.
ENGLISH OMEGA-300 RGB User manual CH6 Y axis rolling CH7 X axis rolling CH8 Z axis rolling CH9 X axis mobile CH10 Y axis mobile 000-127 128-191 192-255 000-127 128-191 192-255 000-127 128-191 192-255 000-127 128-191 192-255 000-127 128-191 192-255 0 -359 degree fixed Y axis rolled Clockwise rolling Anticlockwise rolling 0 -359 degree fixed X axis rolled Clockwise rolling Anticlockwise rolling 0 -359 degree fixed Z axis rolled Clockwise rolling Anticlockwise rolling 128 different fixed position on X axis
ENGLISH 13. SPECIFICATIONS General Laser Class Red Laser Green Laser Blue Laser Laser level AUTO SOUND DMX Channel Range Mains Fuse Consumption Fixture Size (WxHxD) Fixture Weight Carton Size (WxHxD) Carton Weight Professional RGB Graphic Laser Class-3B LD 650nm, 150mw DPSS 532nm, 50mw LD 450nm, 100mw Class 3B Laser Four show AUTO Four show SOUND 1-10 100-240V - 50/60Hz 250V 1 A Slow Blow (20mm Glass) 20W 200 x 80 x 145.5 mm 1.5 kg 247 x 152 x 213 mm 1.
ENGLISH 14. WARRANTY AND SERVICE All SOUNDSATION products feature a limited two-year warranty. This two-year warranty is specific to the date of purchase as shown on your purchase receipt.
This product is imported in EU by Questo prodotto viene importato nella UE da FRENEXPORT SPA – Via Enzo Ferrari, 10 - 62017 Porto Recanati - Italy www.soundsationmusic.
www.soundsationmusic.com Ver 1.
