Owner's manual

WARNING: Warning devices are strictly
regulated and governed by Federal, State and
Municipal ordinances. These devices shall be
used ONLY on approved vehicles. It is the sole
responsibility of the user of these devices to
ensure compliance.
EL3H04A00(x) 7.08
!
WARNING
This product contains high intensity LED devices.
To prevent eye damage, DO NOT stare into light
beam at close range.
MOUNTING INSTRUCTIONS
Before starting the installation make certain you have
the correct bracket for your application. A universal
Deck/Dash mount bracket is supplied. For other
mounting brackets, see product literature or visit our
website.
Install the UltraLITE by following the assembly
instructions provided with the brackets and check for
security.
Important: DO NOT over tighten mounting screws or
nuts. This could cause permanent damage to the light
or bracket. Use appropriate hardware for mounting.
Universal bracket shown is supplied but mounting
screws are customer supplied.
PATTERN SELECTION
1. Connect black wire to ground.
2. Connect red wire to +12Vdc
3. Apply +12Vdc to white wire for less than one
second (momentary) to move forward one pattern.
4. Apply +12Vdc to white wire for one second (until
the lights dim) to move backwards one pattern
5. Apply +12Vdc to white wire for more than two
seconds (until the lights turn off) to turn off the
UltraLITE.
6. To turn the unit back on, apply +12Vdc to the white
wire momentarily.
FLASH PATTERNS
# Pattern Name
1 Quint Flash Alternating
2 Warp Flash Alternating
3 Inter-cycle Flash Alternating
4 Double Flash Alternating
5 Quad Flash Alternating
6 3 Flashes / Second Alternating
7 3 Flashes / Second Simultaneous
8 Q-Switch Alternating
9 Driver Side Steady Burn
Passenger Side Road Runner Flash
10 Driver Side Steady Burn
Passenger Side Quint Flash
11 E-Pattern Single Flash Alternating
12 E-Pattern Double Flash Alternating
13 E-Pattern Single Flash Simultaneous
14 E-Pattern Double Flash Simultaneous
15 Q-Switch Every other
16 LiteRyder Slow Sweep
17 LiteRyder 2 Fast Sweep
18 Progressive Alternating
19 Center Steady Burn
Ends RoadRunner Flash - Alternating
20 Center Steady Burn
Ends Intercycle - Alternating
21 Center Steady Burn
Ends Q-Switch - Alternating
Input Voltage: 10-16Vdc
Current: 2 Amps Maximum
Wire Color Connect to:
Red +12Vdc
Black Ground (-)
White Pattern Select
WIRE HOOK-UP TABLE
BLACK
RED
WHITE
4 MODULE UltraLITE+12Vdc
5A FUSE
4 MODULE BAR
ASSEMBLY INSTRUCTIONS
EL3HØ4AØØ(x)
UNIVERSAL BRACKET
SUPPLIED BAR
MOUNTING HARDWARE