Owner manual

SPLIT ARROW LED TRAFFIC MASTER Page 6 Page 5 SPLIT ARROW LED TRAFFIC MASTER
Figure 2. Mounting Congurations
(View shown from rear of LED Bar)
3. MounttheSplitArrowLEDTrafcMasterbracketonthefrontorrearof
thelightbarframeasdesired.Useeitherexistingholesinthelightbar
frame,ifavailable,ordrillholesasneeded.
NOTE
Remembertoproperlysealallholesmadeinanylightbarto
preventwaterdamage.
4. TurnthelightbarrightsideupandattachtheSplitArrowLEDTrafc
MastertoitsmountingbracketasshowninFigure4.Use ONLY 5 x
10mm bolts.
5. Putthelightbaronthevehicleroofmakingsurenottoscratchtheve-
hicle.Checkforclearancebelowthelightbarasyouproceed.
6. Repositionthelightbarandsecureittothevehicle.
7. TightentheboltsthatholdtheSplitArrowLEDTrafcMastermounting
brackettothelightbar,checkingthatthebracketsarealignedwitheach
other.Someadjustmentofthesebracketsmayberequiredtoinsure
thatthedirectionalsignalislevel.Adjustasnecessary.
8. PositiontheSplitArrowLEDTrafcMasterinthecenterofthevehicle
andtightentheboltsthatholdittothemountingbracket.
Figure 3. Rear Deck Mounting
Figure 4. Light Bar Mounting
NOTE
Use 5 x 10mm Bolt ONLY when
attaching “L” Bracket to the
back of the LED Bar.
NOTE
Use 5 x 10mm Bolt ONLY when
attaching “L” Bracket to the
back of the LED Bar.
TO
FRONTOFVEHICLE
(OPTIONALWIRING)
LIGHTBAR2
LIGHTBAR1
TO
REAROFVEHICLE
(STANDARDWIRING)
LIGHTBAR1
LIGHTBAR2