Owner manual

Figure D.
Special Pattern Options On/Off Switching
WARRANTY
SoundOff Signal warranties the Photon Strobe Power Supply
for five (5) years from the date of purchase to the original pur-
chaser against any manufactured defects or workmanship.
This warranty is a 100% replacement value warranty. It ap-
plies only to units installed according to manufacturer’s in-
stallation instructions and operated within the units specifica-
tions.
Warranty is void if the unit was installed incorrectly or mali-
ciously damaged.
All warranty claims must be accompanied by a dated proof of
purchase.
SoundOff Signal retains the right to be the sole mediator of
what constitutes defects in performance or manufacturing.
STROBE POWER SUPPLY
15 AMP
FUSE
SPST ON/OFF SWITCH
(REAR VIEW)
(+) 8-30 VDC
RED (+)
GREEN
BLUE
GREY
(BROWN)
YELLOW
BLACK (-)
Figure C.
Quad Flash All Heads High/Low Switching
STROBE POWER SUPPLY
15 AMP
FUSE
TWO SPST ON/OFF SWITCHES
(REAR VIEW)
(+) 8-30 VDC
RED (+)
GREEN
BLUE
GREY
(BROWN)
BLACK (-)
DIRECT CONNECTION
OPTIONAL CONNECTION
OPTIONAL STROBE POWER SUPPLY
DIAGNOSTIC PANEL
FOR USE WITH DIAGNOSTIC EQUIPPED POWER SUPPLIES ONLY
M
OUNTING OPTIONS:
1
. Display will snap into any existing
panel with a 22.5mm x 40mm hole.
2
. Remove tabs from the back of
display and adhere to mounting
surface using double sided tape.
I
NSTALLATION:
P
lug the RJ11 end of the cable into the Diagnostic Display.
R
oute the other end of the cable to the Power Supply and
c
onnect the 4-pin Amp Connector.
O
PERATION:
E
ach numbered LED will flash with the corresponding
n
umbered Strobe Tube showing everything is operational. If
a
n LED light stay ON, instead of flashing, there is a problem
w
ith that particular Strobe Tube or Strobe Cable. Low
I
ntensity LED will indicate when the Power Supply is low
p
ower.
T
o Reduce EMI emissions, ONE end of the shield (drain wire)
o
f the extension cable connecting the output of the power
s
upply to the Lighthead should be connected to ground.
M
ake sure ONLY ONE END of the shield is tied to ground.
T
he other end needs to be taped or cut.
TABS
4 - HEAD
PEDIPNL4/
PEDIPNL4WP
1
3
2
4
LOW
INTENSITY
1
3
2
4
56
LOW
INTENSITY
1
3
2
4
56
LOW
INTENSITY
78
6 - HEAD
PEDIPNL6/
PEDIPNL6WP
8 - HEAD
PEDIPNL8