Owner's manual

ENFSLXSS 7.12
4.91
2.46
SINGLE SURFACE MOUNT TEMPLATE
SECONDS USER INTERFACE
FROM TO VISUAL FEEDBACK ACTION TAKEN
0 1 STEADY-HIGH (60%) FORWARD ONE PATTERN
1 2 STEADY-LOW (30%) BACKWARD ONE PATTERN
2 3 OFF COLOR SWAP (OFF OR ON )
3 4 STEADY - HIGH SEQUENCE TYPE (1 OR 2)
4 5 STEADY - LOW RESET TO PATTERN 1
5 6 OFF
FACTORY RESET (PATTERN 1, COLOR
SWAP: OFF, SEQUENCE TYPE: 1)
If held longer than 6 seconds, the light will go back to flashing the current
pattern and no action will be taken.
PATTERN SELECT & SYNC
CONFIGURATION INSTRUCTIONS
Connecting the WHITE wire to power will
allow you to use the secondary feature on
your Nexus Secondary Light.
SECONDARY FEATURE:
• 1-color module = Cruise Mode
(10% brightness, non - ashing)
• 2 & 3 - color modules = Takedown
(100% Steady - burn)
- For 2-color modules this is the 2nd color
- For 3-color modules, this is the 3rd color
SETUP LIGHTS:
• Sequence type
-1 or 2. The modules will ash simultane-
ously if they are set to the same number.
The modules will have an alternate ash if
set to different numbers.
• Color swap
- Off or On. 2-color and 3-color modules, it
changes which color ashes rst.
This is useful when syncing multiple lights
PILOT HOLE
LOCATION
2X
HOLE
.25
Touching the WHITE wire to the ground will allow
you to change various setting on the module.
“
“
“
SLAVE MODE
The NFORCE™ is capable of being activated through the use of a user
supplied flasher by putting it in Slave Mode.
1. Permanently connect the NFORCE™ WHITE and BLACK wire to a good,
convenient ground.
2. Connect the NFORCE™ RED wire, through a 5amp fuse, to the output of
a +10-16Vdc switching flasher.
4.91"
1.30"
2.46"
PILOT HOLE
LOCATION 2X
.25"
HOLE
2X
DOUBLE SURFACE MOUNT TEMPLATE