Operation Manual

2. During play or pause mode, if Skip down button (11) is pressed, it will go back to the beginning of the track,
same track no. is display and continuous the play or pause mode.
3. After step 2, press skip down button (11) again, it will go to the previous track and continuous the play or pause
mode.
 For MP3 disc/file
1. Place the MP3-CD to CD compartment. After focus search is performing, the total number of track will be shown on
the LCD display (16).
2. Press Skip up or Skip down (11) button to select the track number.
3. When the desired track and album is being selected, press the “ Play/Pause ” button (13) to start playback.
Remark
- Press “ Folder up or down “ button (9/10) on main unit can select the MP3 folder directly.
- The number of folder will display on LCD (16) for 1-2 seconds selected and then it will resume to the number of the
track being playback
 Repeat/Random mode
Press the “ Rep/Ran “ button (3) during playback to select repeat and random function, a single track, single folder (MP3
only) or all the tracks can be played in difference mode as follow:-
For CD
(1) Repeat 1 (2) Repeat all track (3) Random (4) Off mode
Indicator
Play mode on LCD display
Repeat track REP
Repeat all REP
Random RANDOM
Off mode --------------
For MP3 disc/file
(1) Repeat 1 (2) Repeat 1 folder (3) Repeat all tracks (4) Random (5) Off mode
Indicator
Play mode on LCD display
Repeat single track REP
Repeat single folder REP & flashing
Repeat all tracks REP
Random RAN
Off mode -----------------
 Repeat play
You can listen the desired tracks or folder repeatedly by this function.
 Random play
You can listen all the tracks in a random order by this function
CD / MP3 disc programming
Up to 20 tacks can be programmed for disc play in any order. Before use, be sure to press the stop button.
1. Set in CD mode.
2. Press the Memory button (2), “ MEMORY “ & “ P01 ” will appear and flashing on LCD display (16).
3. Select a desired track by using the Skip up /Skip down buttons (11).
4. Press the Memory button (2) to enter the track into the memory.
5. Repeat steps 3 and 4 to enter additional tracks into the memory if necessary.
6. When all the desired tracks have been programmed, press “ Play/Pause “ button (13) to play the disc in the
order you have programmed.
7. Press “ Stop ” button (14) to terminate program play.
 Press “ Stop ” button (13) at CD stop mode to cancel all programmed memory until the “ MEMORY “ indicator
disappear on LCD display (16).
 For MP3 disc / file, press the “ Folder up “ button (10) to select the 1
st
track of next folder directly and hence to speed
up the song selection.
 The programming mode will automatically stop if no button is being pressed in a period of about 30 seconds after
pressing the Memory button (2).
3