Operation Manual

ENGLISH
ENG 2
DC CONNECTION
FOR DC OPERATION, PLEASE INSERT 6 PCS SIZE C (UM-2) BATTERY AT BATTER COMPARTMENT (28) AS
BELOW DIRECTION
SETTING THE CLOCK
1. SET UNIT AT STANDBY MODE.
2. PRESS THE “ MEM/ID3/CLK-ADJ ” BUTTON (8) TO ENTER CLOCK ADJUST MODE. THE LCD DISPLAY (16) WILL
SHOW “ 12HR OR 24HR“. PRESS SKIP
OR SKIP BUTTON (11) TO SELECT THE APPROPIATE AREA
HOUR FORMAT(12HR/24HR). PRESS “ MEM/ID3/CLK-ADJ ” BUTTON (8) AGAIN TO CONFIRM.
3. THE LCD DISPLAY (16) WILL DISPLAY THE FIRST TWO DIGIT OF “00” IS FLASHING. PRESS SKIP OR
SKI
P
BUTTON (11) TO SET THE CORRECT HOUR. PRESS “ MEM/ID3/CLK-ADJ ” BUTTON (8) TO STORE
THE CORRECT HOUR.
4. THE THIRD & FOURTH DIGIT OF “00” IS FLASHING, PRESS THE SKIP
OR SKIP BUTTON (11) TO SET
THE CORRECT MINUTES. THEN PRESS“ MEM/ID3/CLK-ADJ ” BUTTON (8) TO STORE THE CORRECT MINUTE.
TO AVOID THE RE-SET OF CLOCK FREQUENTLY WHEN USING DC OPERATION, PLEASE
INSERT
2 PCS AAA SIZE (UM-4) BATTERY AT THE CLOCK BACK-UP BATTERY COMPARTMENT
(2
9) IN THE DIRECTION AS BELOW DIRECTION:-
REMAR
K: PULL DOWN THE RIBBON WHILE INSERT THE BATTERY, THIS CAN HELP TO RELEASE IT
EASIER
WHEN CHANGING THE BATTERY IN THE NEXT TIME.
LISTENING TO RADIO
OPERATION
1. TURN ON THE POWER (6) AND PRESS THE FUNCTION BUTTON (7) TO SELECT TUNER MODE.
2. SELECT THE DESIRE RADIO BAND (AM OR FM) AT “ BAND “ SELECTOR (25).
3. TURN THE TUNING KNOB (12)TO SET THE STATION FREQUENCY AS DESIRED.
4. ADJUST VOLUME KNOW (5) TO THE DESIRED VOLUME LEVEL.
HINTS FOR BEST RECEPTION:-
- AM : THE RECEIVER HAS A BUILT-IN AM BAR ANTENNA. IF AM RECEPTION IS WEAK, SLIGHTLY ROTATE OR
RE-POSITIONING OF THE UNIT WILL USUALLY IMPROVE THE AM RECEPTION.
- FM : THE RECEIVER HAS ROD ANTENNA (26) HANGING AT THE REAR CABINET. THIS WIRE SHOULD BE
TOTALLY UNRAVELED AND EXTENDED FOR BEST RECEPTION.