Operation Manual

E-1
LOCATION OF CONTROLS
1) DUST COVER
2) LCD DISPLAY
3) CD TRAY OPEN/CLOSE BUTTON
4) CD TRAY
5) 3.5MM AUX IN JACK
6) 3.5MM HEADPHONE JACK
7) PANEL COVER
8) USB SOCKET
9) SD/MMC CARD SLOT
10) STANDBY LED INDICATOR
11) POWER ON/STANDBY BUTTON
12) FUNCTION
BUTTON
13) MEMORY/CLOCK-ADJUST BUTTON
14) FOLDER/PRE-UP BUTTON
15)
RECORD BUTTON
16) EJECT BUTTON
17) BAND / PLAY/PAUSE
BUTTON
18) TUNING/SKIP UP
/
19) STOP
BUTTON
20) TUNING/SKIP DOWN
BUTTON
21) ST/MONO-PLAY MODE BUTTON
22) PRESET EQ BUTTON
23) VOLUME UP/DOWN BUTTON
24) REMOTE SENSOR
25) SPINDLE ADAPTOR
26) STROBE ILLUMINATOR
27) ALIGNMENT SCREW WITH RUBBER COVER
28) COUNTER WEIGHT
29) ANTISKATING
30) CUEING LEVER
31) TONE-ARM LOCK
32) TURNTABLE SPEED SELECTOR
33)
PITCH ADJUSTMENT
34) SPEAKER TERMINAL (L/R)
35) LINE OUT SOCKET (L/R)
36) 75 OHM FM SOCKET
37) AC CORD
CAUTION:
USAGE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE
SPECIFIED HEREIN MAY RESULTE IN HAZARDOUS RADIATION EXPOSURE.
THIS UNIT SHOULD NOT BE ADJUSTED OR REPAIRED BY ANYONE EXCEPT QUALIFIED SERVICE
PERSONNEL.
PRECAUTIONS FOR USE
INSTALLATION
• UNPACK ALL PARTS AND REMOVE PROTECTIVE MATERIAL.
• DO NOT CONNECT THE UNIT TO THE MAINS BEFORE CHECKING THE MAINS VOLTAGE AND BEFORE
ALL OTHER CONNECTIONS HAVE BEEN MADE.
• DO NOT COVER ANY VENTS AND MAKE SURE THAT THERE IS A SPACE OF SEVERAL CENTIMETERS
AROUND THE UNIT FOR
VENTILATION.
INSTALLATION OF COUNTER WEIGHT
1. SLIDE IN THE COUNTER WEIGHT COMPLETELY INTO THE REAR OF THE TONE ARM UNTIL IT REACH
THE ENDˈTURN IT CLOCKWISE UNTIL IT CLICK WITH PIT INSIDE.
2. TWIST THE COUNTER WEIGHT CLOCKWISE & BACKWARD UNTIL IT REACH THE WHITE LINE AS FIGURE
2
3. TWIST THE COUNTER MARKING
UNTIL IT REACH “ 1 “ POSITION
4. TWIST THE COUNTER WEIGHT ANTI-CLOCKWISE & INWARD UNTIL IT REACH THE APPROPIATE
WORKING PRESSURE.