Operation Manual

GB - 5
CARE AND MAINTENANCE
Caring for Discs
• Treat the disc carefully. Handle the disc only by its edges. Never
allow your fingers to come in contact with the shiny, unprinted
side of the disc.
• Do not attach adhesive tape, stickers, etc. to the disc label.
• Clean the disc periodically with a soft, lint-free, dry cloth. Never
use detergents or abrasive cleaners to clean the disc. If
necessary, use a CD cleaning kit.
• If a disc skips or gets stuck on a section of the disc, it is
probably dirty or damaged (scratched).
• When cleaning the disc, wipe in straight lines from the center of
the disc to the outer edge of the disc. Never wipe in circular motions.
• Discs should be stored in their cases after each use to avoid damage.
• Do not expose discs to direct sunlight, high humidity, high temperatures or dust, etc. Prolonged
exposure or extreme temperatures can warp the disc.
• Do not stick or write anything on either side of the disc. Sharp writing instruments, or the ink, may
damage the surface.
Cleaning the Unit
• To prevent fire or shock hazard, disconnect your unit from the AC power source when cleaning.
• The finish on your unit may be cleaned with a dust cloth and cared for as other furniture. Use
caution when cleaning and wiping the plastic parts.
• Mild soap and a damp cloth may be used on the front panel.
Check the following guide for the possible cause of a problem before contacting service.
Symptom
Player will not turn on.
Disc will not play
Erratic CD playback
No sound from speakers
Cause
• AC line cord not connected.
• CD Compartment not closed.
• Disc inserted incorrectly.
• Dirty or defective disc.
• Moisture condensation on disc.
• Dirty or defective disc.
• Player is subject to vibrations or
physical shock.
• Laser lens is dirty.
•
ON/OFF button not selected to ON
• Voulme +/- button not controlled
•
CD/AUX button not selected to
ON.
Correction
• Check AC line cord connecting.
• Close CD Compartment.
• Reinsert disc correctly.
• Try another disc.
• Wipe disc with soft cloth.
• Clean or replace disc.
• Change the installation location.
• Clean using a quality laser lens cleaner.
• Press the ON/OFF button to ON (
).
• Press the VOLUME + button to
increase sound level.
• Press the CD/AUX button to CD mode
(
), or AUX mode ( )
TROUBLESHOOTING GUIDE
SPECIFICATIONS
Power source AC 220V-240V ~ 60Hz
Power consumption 12W
Frequency response 100 – 18,000 Hz
Power Output 1W + 1W
Speaker 2.5" 8 ohms x 2
External dimensions 280 (L) x 200 (W) x 215 (H) mm
* Design and specification are subject to change without notice.