Owner's Manual

Mounting Instructions:

Wiring Instructions:

1. Find the mounting location and determine which conguration to install the

provided L-Bracket. Please reference pages 5-6 for the different congurations.

Fasten the L-Bracket to the soundbar loosely.

If installing on a gas vehicle:

If installing on a electric vehicle:

1. Carefully remove the Positive (+) then Negative (-) battery wires.

2. Carefully remove the Positive (+) then Negative (-) battery wires.

1. Switch the electric vehicle into Tow Mode under the seat.

*If using a 16V or higher battery system, a DC-DC converter is required.

2. Hold the L-Bracket in place on the soundbar when using conguration A or B.

Take an M8 x 45mm bolt (25mm if not using a spacer) using a at washer and

lock washer and loosely fasten the L-Bracket to the soundbar. When mounting

in conguration C or D, do not use a at washer when fastening the L-Bracket

to the soundbar. We recommend using threadlocker on these bolts.

2. Connect the Negative (Black) wire to the Negative (-) battery terminal and the

Positive (Red) wire to the Positive (+) battery terminal.

3. Connect the Negative (Black) wire to the Negative (-) terminal and the Positive

(Red) wire to the Positive (+) terminal on the DC-DC converter.

3. Ensure the soundbar is in the desired location, then use the additional M8 x

45mm bolt and tighten it in place using the hex-nuts provided. We recommend

using threadlocker on these bolts.

4. Route the blue AUX Input cable to a desired location.

5. Route the blue AUX Input cable to a desired location.

5. Optional: Route and connect the blue Remote Wire and the blue Signal

Output cable to an additional amplier or Stealth AS subwoofer.

6. Optional: Route and connect the blue Remote Wire and the blue Signal

Output cable to an additional amplier or Stealth AS subwoofer.

4. Adjust the soundbar in the proper orientation and tighten it in the desired

position.

3. Reinstall the Positive (+) then Negative (-) battery wires.

4. Reinstall the Positive (+) then Negative (-) battery wires.

7. Switch back into Run Mode.

Installation Specications

Wet Sounds Stealth XT Soundbar Owner’s Manual