User's Manual

Using - Timer
iMON Manager includes the alarm function that shuts down the PC at the
defined time or sounds alarm after a certain time. To use the timer function, the
‘Timer Setup’ function of Power Management command from Windows Commands and four
direction arrow keys should be registered in iMON Manager in advance.
There are three modes: Sleep, Alarm, and None. Sleep mode shuts down the PC after a
certain period of time. Alarm mode sounds the alarm after a certain period of time. And,
NONE is use to cancel any timer function that is already set.
Time offers two modes: ABS. and REL. Use ABS to enter a certain time and use REL to
enter the relative time to the current time. You can also use arrow keys to set the time.
To register the timer, press the timer button on the remote controller and use up/down
arrow button to select MODE/TIME/Hour/Minute, or use Left/Right arrow button to adjust
the value of each item. Then, press the timer button again. The remote input signal
indicator changes as shown below to indicate the time that the ‘SLEEP/ALARM’ function will
start.
: Timer function Off