User's Manual

Using as WinAmp Only Mode
Using as WinAmp Only Mode option is useful when you listen to music from
WinAmp while you do other task such as documentation. For example, you do not
need to bring up WinAmp and use your mouse or remote control to adjust the music
volume during working with word processor. Instead, you can send all commands from the
remote controller directly to WinAmp. Therefore, checking this checkbox allows you to use
your remote controller to control WinAmp once you launch it just like you operate home
audio system, while you work on the PC word processor. However, the remote controller
button will not operate on other program once you set this option. Uncheck this option if
you want to use your remote controller for several programs. Since this option uses the
remote controller buttons registered for WinAmp, you need to register remote control
buttons for WinAmp functions first in the program setup.
You can select the WinAmp version you are currently using in your PC from WinAmp 2.x
version and the newly released 3.0 version. If you use the WinAmp as default, the remote
input indicator on the desktop changes to the following to indicate that WinAmp is set as
default.
: WinAmp Default Mode Off
: WinAmp Default Mode On
Remote Controller Input Display on the Desktop
This option is useful when you see animation or display presentation. For example,
sometimes you wonder if the TV remote controller signal reaches the TV while you are
watching it. When you use this option, iMON shows the following figure on the PC monitor
screen to indicate whether the remote controller signal is good while you use iMON to see
video or display presentation in a distance.
When there is no remote controller signal, the screen is as shown in the first figure with
yellow light. When you press the remote controller button, the yellow light turns into
green light, if the remote controller signal is registered for active program, to indicate
that the command is sent to the program correctly. The light turns to red if you press the
button that is not registered, if the distance between the remote controller and iMON is too
far, or if the signal is not delivered correctly due to other trouble. When you see the red