User's Manual

If you have imported the basic settings, you do not need to modify the function name since
the application commands are already registered. If you want to change the name, you can
enter the new name (such as Play -> Playback). After you enter the name, click ‘Next’
button to go to Shortcut Key Setting as shown in the figure below.
The above figure shows the area that you enter the shortcut key setting. The shortcut key
for WinAmp ‘Play’ function is ‘X’ key. Since you have imported the basic setting file, the
function name and the shortcut key information is already registered. Click ‘Next’ button
to go to the area to set the remote controller.
Enter the name written on the remote controller or any name you can easily remember for