Operating Instructions and Installation Instructions

Soundcraft Compact Stagebox User/Installation GuidePage 16
If someone wanted now that all 3 modules are inputs to give a 48 input/0 output stagebox, they are con-
nected as follows:
Input module A è top connector on the left side of the backplane (P2)
Input module C è middle connector on the left side of the backplane (P13)
Added input module E è bottom connector on the left side of the backplane (P19).
Supply looms are identical for input and output modules. No particular order has to be followed when re-
connecting them. Like the power connections in a PC, there is one connector more than modules to feed;
this connector is not used.
INSTALLING D21m I/O CARDS
• In the K and L slots, one or two additional D21m input or output cards may be installed.
• In order to do so, rst switch the Compact Stagebox OFF and unplug the mains cable(s).
• Remove the blank panel(s) with a size 2 screwdriver and insert the D21m card(s). Re-tighten their
screws.
• Connect the Compact Stagebox to the mains again, switch it on and press the RECONFIG button
with a small tool (e.g. a size 2.5 Allen screwdriver).
• Remember that the new input/output count needs to be congured in your console’s I/O mapping.
Please refer to its user guide.
For more information on the D21m cards please refer to the ‘Vi IO Option Cards Technical Information’
document available from www.soundcraft.com in the ‘Downloads’ - ‘User Guides’ - ‘Soundcraft Vi1’ area.
REPLACING/CLEANING THE FAN AIR FILTER MAT
• For cleaning or replacing the air lter mat, just pull the black frame away from the fan air inlet and
remove the lter mat.
• In order to clean the lter mat, thoroughly rinse it with warm water and let it dry completely before
reinstalling it.