User's Manual

7. Information to User

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) This device must accept

any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for Class B Digital Device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates and

can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of

the following measures.

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected

• Consult the dealer or an experienced radio/TV technician for help

Any changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

All products in which this device will be installed shall be labeled with “This device

complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) This device must

accept any interference received, including interference that may cause undesired

operation” and “This device contains FCC ID: SUD-SCG2 / IC: 5613A-SCG2” or

“This device contains FCC ID: SUD-SCG2ER / IC: 5613A-SCG2ER” as appropriate for

model.

8. Human Exposure Compliance Statement

The following statement addressing human exposure to the RF energy emitted by SCG2 and

SCG2ER wireless audio systems is included in the “User's Manual." Pursuant to 47 CFR § 15C

of the FCC Rules and Regulations. KSC Industries, Inc. certifies that it has determined that the

SCG2 and SCG2ER comply with the RF hazard requirements applicable to unlicensed

transmitters under the authority of 47 CFR Part 15 of the FCC Rules and Regulations. This

determination is dependent upon installation, operation and use of the equipment in accordance

with all instructions provided. The SCG2 and SCG2ER are designed for and intended to be used

in fixed and mobile applications. "Fixed" means that the device is physically secured at one

location and is not able to be easily moved to another location. "Mobile" means that the device is

designed to be used in other than fixed locations and generally in such a way that a separation

distance of at least 20 cm is normally maintained between the transmitter's antenna and the body

of the user or nearby persons. The EUT is not designed for or intended to be used in portable

applications (within 20 cm of the body of the user) and such uses are strictly prohibited. To

ensure that the SCG2 and SCG2ER comply with current FCC regulations limiting both maximum

RF output power and human exposure to radio frequency radiation, a separation distance of at