- SPL RackPack Product Manual

RackPack

Link Cable Installation (Top View)

Two modules supporting the LINK feature (i. e. Transient Designer & DynaMaxx) can be run

as stereo pairs. In LINK mode, the master module controls the slave module and allows a

coherent processing of stereo programs over both channels. Besides coherent stereo oper-

ations the LINK mode offers further interesting applications, please refer to the individual

manuals of the modules for further details.

IMPORTANT: You have to specify the master or slave conguration of a module before you t

a module into the RackPack frame. The module manuals explain how to congure a module

for master or slave mode.

All modules supporting LINK mode have a 10-pin-socket on the top of their circuit board. A

at ribbon cable with two 10-pin-connectors is part of the module’s scope of delivery.

Plug one of the two multi pin connectors of the ribbon cable into either one of the multi-pin

sockets of the modules to be connected. Make sure that the connections are safe by plugging

the connector completely into the socket.

IMPORTANT: Only pull or push the connector, never the cable! Otherwise you risk to damage

the cable. Subsequent damages can affect one or more modules!

Link Cable Installation

Fitting Modules

'MBUSJCCPODBCMFXJUIFJHIUQMVHT

UPQPXFSUIFNPEVMFT

'MBUSJCCPODBCMFXJUIUXPQMVHTUPDPOOFDU

UXPNPEVMFTGPS-*/,NPEF

.0%6-& .0%6-& .0%6-& .0%6-&