Owner's Manual

CONNECTIONS
Power Wire (BAT+)
• Disconnect the negative battery
terminal before proceeding. Call
1-800-955-9094 for instructions if
you are unsure.
• Plan wire routing before cutting
any wires to length. Begin by rout-
ing the power BAT+ wire from the
battery to the subwoofer location.
Use a grommet when running wires
through the firewall or metal open-
ings. Avoid running the power wire
near existing vehicle wiring to
prevent induced noise from entering
the audio system.
• Exercise caution when drilling
holes to avoid damaging fuel lines
or existing vehicle wiring.
• The BAT+ wire MUST be fused within
18" of the battery for protection
of the vehicle's electrical system.
Ground Wire (GND)
The subwoofer's ground wire should
be as short as possible. Choose a
clean unpainted section of metal or
the vehicle chassis when attaching
the ground connection. Be sure
to clean the area of any dirt or
grease.
Remote Turn-on Wire (REM)
• The remote turn-on wire connects
to the head unit's amplifier turn-
on lead or other switched 12-volt
source.
Input Signal
• The subwoofer's input signal con-
nects to the head unit's low level
(RCA) or high level (speaker wire)
outputs.
• Dedicated subwoofer or low level
inputs signal deliver the best
performance. If unavailable, use
the high level inputs - when
interfacing with factory head unit
for instance. Be sure to observe
the correct polarity when using the
high level inputs.
5