sound ordnance powered subwoofers b-8p b-8pt
Thank you for purchasing Sound Ordnance You re now ready to win the battle for great sound. To ensure safe operation, always follow the instructions and guidelines in this manual. Keep this manual handy for reference. www.soundordnance.com All rights reserved. TABLE OF CONTENTS Safety Instructions ................................................... 3 Setup and Installation ................................................ 4 Connections ...........................................................
SAFETY INSTRUCTIONS ! The product s warranty is rendered void in cases of damage resulting from failure to comply with safety and operating instructions. We do not accept any liability for consequential damages. We do not accept any liability for personal injury or damage to property caused by incorrect handling of the device or failure to observe the safety and operating instructions. In such cases the warranty is rendered void. High volume levels can cause hearing damage or loss.
SETUP AND INSTALLATION ! To ensure proper operation, please read these instructions carefully before installing and using this powered subwoofer. These installation instructions do not cover all possible installation issues. If you re not con dent about installing your powered subwoofer, call us at 1-800-955-9094. 1. Read and understand the instructions before attempting to install this powered subwoofer. 2. Disconnect the negative terminal from the battery prior to starting the installation.
CONNECTIONS ! Do not use both low and high level inputs at the same time connect only one or the other. Never run any wires underneath or outside the vehicle. NOTE: Be sure to follow speci c instructions included with your ampli er installation kit (not included with this powered subwoofer). The information below should be used a general guideline only. Power Wire (BAT+) • Disconnect the negative battery terminal before proceeding. Call 1-800-955-9094 for instructions if you are unsure.
B-8P Connections and Controls FREQUENCY 70Hz 200Hz PHASE 0° LEVEL 180° MAX HIGH LEVEL INPUT LINE IN L MIN POWER R L+ R+ L– R– GND REM +12V FUSE 7.
WIRING B-8P/B-8PT GND (ground) CAR STEREO RECEIVER + – L R battery fuse RCA cables LEVEL INPUT L R GND REM +12V 7
CONTROLS AND SETUP POWER MODE (AUTO MODE) Set the switch to AUTO MODE is your system setup doesn’t have a remote wire, as with stock head units. The subwoofer will turn on automatically when it detects an incoming signal (this feature only available on the B8-PT). POWER MODE (REMOTE WIRE) Set the switch to REMOTE WIRE if you have attached a remote turn-on lead to the subwoofer.
TROUBLESHOOTING PROBLEM CAUSE ACTION Unit will not turn on (no power LED indicator) • BAT+ wire not connected or incorrect voltage REM wire not connected or incorrect voltage • Check connections for proper voltage (11~16VDC) • GND wire not connected • Check connection to ground • Fuse(s) blown • Replace fuse(s) • Volume turned all the way down • Increase volume level at head unit • Speaker defective or damaged • Check/replace speaker • Input signal not connected • Check high or low level inpu
SPECIFICATIONS 10 B-8P B-8PT Maximum Output Power 160 W 250 W Continuous Output Power 80 W 120 W Frequency Response 20-200Hz 40-200Hz W Crossover Frequency 70-200Hz 80-200Hz Crossover Slope 6dB/octabe 18dB/octave Phase 0-180 degrees 0-180 degrees Fuse 1 x 7.
To ensure safe operation, always follow the instructions and guidelines in this manual. Keep this manual handy for reference. www.soundordnance.com All rights reserved. Manual revised December, 2010.
Virtual Gateways LLC™ Limited Warranty (Valid Only in the U.S.A. and Canada) Virtual Gateways LLC (“Virtual”) warrants this Product (expressly excluding any accessories) against defects in material or workmanship as follows: Terms of warranty coverage: This warranty covers the product during the warranty period so long as the product is owned by the same individual whose name appears on the invoice received upon purchase of the product.
