SftlINI) ftlll)Nl'N(~I~ l)f)"TI~111~1) S'JB"Tf)f)I~I~11S II-III) 11_111)'1'
Thank you for purchasing Sound Ordnance You're now ready to win the battle for great sound. To ensure safe operation, always follow the instructions and guidelines in this manual. Keep this manual handy for reference. www.soundordnance.com All rights reserved.
SAFETY INSTRUCTIONS The product's warranty is rendered void in cases of damage r!st..dtingfrom f(JiI~re to comply with safety and operating instruc·/tiC)n$.~edonot accept any liability ·for consequential damages. We do riot accept any liability for personal iniury or damage to ··pl"opertycaused· by incorrect handling of the device or failure to observe the safety and operating instructions. In such cases the ·>,warranty is rendered void. ·tiighvolume levels can cause hearing damage or loss.
SETUP AND INSTALLATION A To ensure proper operation, please read these instructi()ns.FC(JIl~tQllly before installing and using this· powered sut.wc.ot~~r, These installation instructions do not cover. all. possibleinstaUation issues. If you're not confident about installing your powered sub.. woofer, call us at 1-800-955-9094. 1. Read and understand the instructions before attempting to install this powered subwoofer. 2.
CONNECTIONS .,Po not use both low and high level inputs at the same time 'connect only one or the other. > Never run.any wires< underneath or outs.ide the vehicle. N,OTE: Be sure to follow specific instructions included with your am'pJiflerinstaliation kit(not included with this poweredsubwoofer). The . information below should be 'used ageneralguidel,ine only. Power Wire (BAT+) • Disconnect the negative battery terminal before proceeding. Call 1-800-955-9094 for instructions if you are unsure.
B-8P Connections and Controls B-8PT Connections 6
WIRING B-8P/B-8PT GND (ground) Oo CAR STEREO RECEIVER 0 0 0 0 0 + L R battery fuse RCA cables 7
CONTROLS AND SETUP POWER MODE (AUTO MODE) Set the switch to AUTO MODE is your system setup doesn't have a remote wire, as with stock head units. The subwoofer will turn on automatically when it detects an incoming signal. POWER MODE (REMOTE WIRE) Set the switch to REMOTE WIRE is you have attached a remote turn-on lead to the subwoofer. LEVEL The LEVEL control (gain) is used to obtain the best possible match between the head unit audio output and the amplifier input.
TROUBLESHOOTING PROBLEM CAUSE ACTION Unit will not turn on (no power LED indicator) • BAT+ wire not connected or incorrect voltage REM wire not connected or incorrect voltage • Check connections for proper voltage (11~16VDC) • GND wire not connected • Check connection to ground • Fuse(s) blown • Replace fuse(s) • Volume turned all the way down • Increase volume level at head unit • Speaker defective or damaged • Check/replace speaker • Input signal not connected • Check high or low level inpu
SPECI FICATIONS 10 B-8P B-8PT Maximum Output Power 160 W 250 W Continuous Output Power 80 W 120 W Frequency Response 20-200Hz 40-200Hz W Crossover Frequency 70-200Hz 80-200Hz Crossover Slope 6dB/octabe 18dE/octave Phase 0-180 degrees 0-180 degrees Fuse 1 x 7.
To ensure safe operation, always follow the instructions and guidelines in this manual. Keep this manual handy for reference. www.soundordnance.com All rights reserved.
Virtual Gateways LLC™ Limited Warranty (Valid Only in the U.S.A. and Canada) Virtual Gateways LLC (“Virtual”) warrants this Product (expressly excluding any accessories) against defects in material or workmanship as follows: Terms of warranty coverage: This warranty covers the product during the warranty period so long as the product is owned by the same individual whose name appears on the invoice received upon purchase of the product.
