User Manual

Scorpio Preliminary User Guide
13
Outputs
1. LR, X1-X10 Output Routing
Selects routing for L,R and X1-X10 outputs [L Out, R Out, X1, X2, X3,
X4, X5, X6, X7, X8, X9 and X10 Out] * Only a single source can be rout-
ed to an Output. If multiple sources need to be routed, use a Bus*
A. ISO Selected source will contribute to the Output. Green = Pre-
fade, Orange = Post-fade. [1-32]
B. BUS [L,R, 1-10, HP-L, HP-R]
C. COM [Send 1, Send 2, RTN 1, RTN 2]
D. RETURN COM [A1, A2, B1, B2, C1, C2]
E. AUTO-MUTE Selects automatic muting of the output when in Stop
mode. Record and Playback modes are not muted.
F. DELAY The output delay is continuously-variable in milliseconds
from 0-500 ms.
G. GAIN Selects amount of attenuation applied to the output. Toggle
the ** to select [0 dB to -50 dB and -inf]
H. LEVEL Selects output level type. [Line, -10, Mic]
J. MUTE Indicates mute status of output. Orange = muted. Toggle
Mute On/Off with the “Fav” toggle.
2. 10-Pin A Out Routing
Selects routing for 10-Pin A outputs.
A. A1 Selects mix bus for A1 output [L,R, 1-10]
B. A2 Selects mix bus for A2 output [L,R, 1-10]
C. AUTO-MUTE Selects automatic muting of the output when in Stop
mode. Record and Playback modes are not muted.
D. DELAY The output delay is continuously-variable in milliseconds
from 0-500 ms.
E. GAIN Selects amount of attenuation applied to the output. Toggle
the ** to select [0 dB to -50 dB and -inf]
F. LEVEL Selects output level type. AES option is available for L, R,
10-pin A [Line, -10, Mic]
G. MUTE Indicates mute status of bus. Blue icon = muted. Toggle
Mute On/Off with the “Fav” toggle.
3. 10-Pin C Level
Selects the output level type. [Line*, -10, Mic]
A1
A2
Link
Delay
Attn Type
Mute
Auto-Mute
4. Dante
Selects routing for Dante outputs.
A. ISO Any source selected will be routed to the selected Dante out-
put. Green ll in text box = Pre-fade, Orange ll in text box = Post-fade.
[1-32]
B. BUS [L,R, 1-10]
C. OUTPUT All sources are selected post-delay. [L,R, X1-X10]