User Manual
User Guide
24
Using Solo/Mute
The MixPre-10M oers a few dierent ways to mute or solo tracks.
• From each track’s Channel screen, tap Mute to mute the selected track. This
removes the signal from recorded tracks, mix and all outputs. When muted,
its LED ring will glow red. Multiple tracks may be muted at the same time.
• From each track’s Channel screen, tap Solo to hear only the selected track
(pre-fade/pre-eects) in both ears of the headphone output. When a track
is soloed, its LED ring will ash orange.
Like Mute, soloing is non-exclusive, meaning any number of inputs may be
soloed at the same time.
You can quickly solo/mute several tracks from the Solo/Mute screen. All 12
tracks’ Solos and Mutes may be viewed and set from this screen.
L Access to it may also be set as a shortcut for the */** switch.
To solo or mute tracks from the Solo/Mute screen:
1. Tap . The Music Control screen appears.
2. Tap Solo/Mute. The Solo/Mute screen appears.
3. Do either of the following:
X Tap either Solo or Mute and then tap track(s) to select them. Soloed
channels appear orange; muted tracks appear red.
X Use the HP encoder to highlight (green outline) a track and then tap
either Solo or Mute.
4. Tap to exit the screen.
Arming a Track
Armed tracks appear with red numbered boxes on the Home screen’s Meter
view.
To arm/disarm a track:
X From the Channel screen, tap Arm to enable or disable a track for
recording.