Instruction Manual

Page 6 of 28
Before installation, re-installation, or troubleshooting:
Stop the DL5/DL6
Pull out the mains plug.
Relieve the DL5/DL6 of any loads, which may be released during the
work.
Before start-up:
Make sure that the system has been installed as instructed in this User
Manual.
Make sure that the voltage of the control box is correct before the
system is connected to the mains.
System connection. The individual parts must be connected before the
control box is connected to the mains. See the User Manual for LINAK
actuators, if necessary.
During operation
If the control box makes unusual noise or smells, switch off the mains
voltage immediately.
Take care that the cables are not damaged.
Unplug the mains cable on mobile equipment before it is moved.
The products must only be used in an environment, that corresponds to
their IP protection.
Misc.
The actuator system has a sound level below 55dB(A) in typical
applications.
Updated manuals and declarations can always be found here:
www.linak.com/deskline