User's Manual
Table Of Contents
- 1. Introduction
- 2. Definitions
- 3. Spider SAS Overview
- 4. Precautions for use and maintenance
- 5. Cleaning
- 6. User profile
- 7. General description
- 8. Patient Use
- 9. How to pair Spider SAS (Windows)
- 10. Starting a recording with HookUp RS
- 11. Starting recording: anonymous mode
- 12. Stopping a recording
- 13. Software, hardware and accessories
- 14. Technical specifications
- 15. Appendix 1: Patient recommendations
- 16. Appendix 2: electromagnetic compatibility
- 16.1. Guidance and manufacturer's declaration
- 16.2. Guidance and manufacturer's declaration: cable length
- 16.3. Guidance and manufacturer's declaration: electromagnetic emissions
- 16.4. Guidance and manufacturer's declaration: magnetic and electromagnetic immunity
- 16.5. Guidance and manufacturer's declaration: electromagnetic immunity, portable RF equipment
- 16.6. Spider SAS and mobiles (recommendations)
2. Insert µSD card (See § 7.1)
3. Insert a new battery in the recorder (See § 7.1)
4. Connect the clips of the ECG cable to electrodes
5. Apply the electrodes to the patient’s chest (See § 8.3)
6. Ask the patient to put on his/her t-shirt
7. Connect the ECG patient cable to the recorder (See § 7.1).
8. Close Spider SAS (See § 7.6)
9. Insert Spider SAS into holster (RG017) then secure it by closing the holster
10. Check all is fine with HookUp RS
11. Adjust the position of the holster around the neck (see § 8.2)
12. In HookUp RS Click on Start button to start the recording (see § 10.1)
10. STARTING A RECORDING WITH HOOKUP RS
SPIDER SAS – PHYSIO HUB – HOOKUP RS – U908F 43